Part Number: XTR111-2EVM i have to make a pcb similar to the board in question. i could use the gerbers to understand the dimensions of the tracks.
Thanks
Regars
Part Number: XTR111 Other Parts Discussed in Thread: XTR117 , XTR300 Hi,
Greetings!!
We are using XTR111 and XTR117 in 3 wire transmitter and loop power transmitter (2 wire).
As I understand 3 wire transmitters are working in current source configuration…
Part Number: XTR111-2EVM Other Parts Discussed in Thread: XTR111 , TIDA-01536 Hello everyone, I'm using the XTR111 to convert a 0-5V input voltage to a 4-20mA output, as shown in the picture below.
I would like to know in this case the transfer function…
Part Number: XTR111 Hi team,
When we used XTR111, we found that the accuracy deviation was very large (0.9%) when outputting 20mA current at high temperature. Under the same circumstances, the voltage accuracy of the front stage is very accurate. Do…
Is XTR111 automotive qualified? is there any other IC from TI , which will meet my requirement , along with automotive qualified or operating junction temperature from -55 to 150deg?
Part Number: XTR111 Other Parts Discussed in Thread: TPS92612-Q1 , LP5560 Hi. I would like to use the XTR111 to drive a standard red LED. Can I use this part without a drive transistor (Q1 in data sheet front page) and if so how could I do this?
Thankyou…
Part Number: XTR111 Other Parts Discussed in Thread: TINA-TI
Hi! I want to select the xtr111 external mosfet Vgs ths(max) value. This value is Vgs ths(max) @ Id 2.5V 3V and 4V. Is it better for this value to be wide or to be in a narrow range? In the…
Hi Electronx,
I believe the designer of the XTR111-2EVM included the 1kΩ resistor so that the input will be weakly pulled to ground in the case that Vreg is disconnected (J3 open) and there is no input connected at the Vin terminal. This ensures that…
Part Number: XTR111 Other Parts Discussed in Thread: XTR117 Hi Dear,
As shown in the figure, is suitable for use with three wire sensors. Is it possible to use it as a two wire sensor? How to connect the circuit? Is there any reference material for 4…