Hello Suren
We try 1 0 2 0, but the result is the same.
We connected to the 4 serial as the given schematic below.
Current DTS setting:
Fullscreen
3323.k3-am62x-sk-common.dtsi.txt
Download
// SPDX-License-Identifier: GPL…
I think I have solved the problem of writing 0x09 and 0x0d registers, but I am not sure of the correctness of the registers, can you please check? I am sharing dmesg outputs. MY DRİVER NAME mipi_convert
sdm660_64:/ # dmesg
[ 0.000000] Booting Linux…
Hi shen,
Please find below update:
Measured all the clocks.
MCLK = 12.28 MHz BCLK = 1.536 MHz WCLK = 47.99 KHz
DIN = We can see data on DIN pin when we are playing audio file.
BUT SPEKER is not throwing any data . Not even noise.
Please help…
Part Number: SK-AM62 Other Parts Discussed in Thread: AM625 Hi .
Plz see the attached line: 5342.
When the Android boot successfully, just leave the EVM there, it will reboot with unknown reason.
Please help to solve.
This issue is reproduced…
Thanks a lot!
But how to avoid this problem? Below is the configuration file that happened error.
[Header] bq EVSW Version = 0.9.90 DeviceName = bq20z95 v1.50 Time = 2019-03-11 19:48:28
[Voltage(1st Level Safety)] COV Threshold = 4300 COV Time …
Hello Biser,
The linux version is:
Linux 4.14.79-gbde58ab01e armv7l
ID="arago" NAME="Arago" VERSION="2018.10" VERSION_ID="2018.10" PRETTY_NAME="Arago 2018.10"
The log file is attached.
I'm also putting the step that I did here:
root@core…
Hello , i am also facing same problem as described earlier in blog.
As a solution i found that , I should uninstall all MSVC and reinstall 2005 and 2012 32-bit.
I tried that and then I tried to reinstall CCS but the error still exist.
Now i found…
Part Number: BQ20Z95 Hello，
my project：Lithium battery pack fuel gauge
I used BQ20Z95 to process it.
This product has been mass-produced and the product has encountered problems.
1）The calibration coefficient of bq20z95 is automatically changed…
Hi J,
When all masks are disabled the interrupt pin goes low, stays low and the link is not established even when 0ohm (R242) is removed from the interrupt line. Please refer the below oscilloscope output. Also log is attached.
Fullscreen…
This project uses AM437x SDK download from here , using Linux platform.
The SDK version is 08.02.00.24, and the kernel version is 5.10.100.
WL1807 module can connect with AP, but it disconnected while doing throughput test(using iperf3). Or ping Google…
