Part Number: MSP-GANG Other Parts Discussed in Thread: MSPM0L1305 , MSPM0L1306 , MSPM0L1306-Q1
Tool/software:
First, we can check our target PCBA is ok, when we use the J-link tool to be programmed it can be successful.
But when we try to program…
Part Number: MSP-GANG Other Parts Discussed in Thread: MSPM0G3507 , MSPM0G1506 Tool/software: I am trying to program MSP( MSPM0G1506 / MSPM0G3507 ) devices with MSP Gang Programmer . I am unable to program/erase/read target devices. Getting an error of…
Hi Daniel,
Refer below thread, make sure the connection of the MSP-GANG is correct (sometimes, I find user will mistake the PIN 1 of the interface).
https://e2e.ti.com/support/microcontrollers/msp-low-power-microcontrollers-group/msp430/f/msp-low…
Part Number: MSP-GANG Other Parts Discussed in Thread: MSP430FR2422 , MSP-FET , MSP-TS430RHL20 , MSP430FR2433 Dear Forum,
I would like to request some support from your side because I found a serious issue by using the MSP-GANG programmer to program…
Hi Pengfei,
Thank you for your reply.
Pengfei Xie said: As you said " the first writing is successful, but Error-23 or Error-33 occurs after multiple tries. ", so I think it is more likely a random issue of programming.
Are customer using the splitter…
Part Number: MSPM0G1105 Hi,
We would like to ask for your support regarding a programming issue we are experiencing.
Programming failure during software write
When programming the device using MSP-GANG Programmer, the programming process…
Hi,
Please check that the device is powered correctly
There are several threads on E2E that provide solutions.
This is a good place to start: https://e2e.ti.com/support/microcontrollers/msp-low-power-microcontrollers-group/msp430/f/msp-low-power…
Part Number: MSP-GANG Other Parts Discussed in Thread: MSPM0G1507 Tool/software: Hello,
While preparing for production with the MSPM0G1507 we discovered that when programming with the MSP-GANG programmer, devices would get permanently locked after a…
Part Number: MSP430FR6043 Hi!
We encountered a problem in manufacturing where a MSP GANG programming file would successfully program a device on the first go, but when you try to re-program it using either the MSP GANG or a MSP FET + Code composer studio…
Other Parts Discussed in Thread: MSP430F149 I have programmed MSP430F149 target board with MSP430-GANG. It was fine.
Recently I am trying to use MSP-GANG instead MSP430-GANG. However, the following error appeared.
ERROR 23: MCU device initialization…
