Part Number: LAUNCHXL-CC1310 Other Parts Discussed in Thread: CC1310 Tool/software: TI-RTOS we are using TICC1310 CCS 9.0 ,simplelink_cc13x0_sdk_3_10_00_11 and sensor_cc1310_launchxl_tirtos_ccs develop our device.
Only,I would like to use the sensor_cc1310_launchxl_tirtos_ccs…
X038-32( 48 )29(X038 电芯测试)(2024-09-12 15_22_22) (2)(2).xlsx Hi Adrian，
We tested it with cell. Is that the right way to test it?Attached is the raw data，please refer，thanks！
Hello,
Tha attachment helped a lot with the question I posted above. However, there is one more detail concerning
the "pin compatibility" for both parts:
Supply Voltage: Does the LM96080 take supply voltages as low as 2.8V like the LM80? I can…
Hi Bob,
i tried with 29 bit Identifier with 0x7DF ID and mask is 0x1FFFFFFF value. i am able to receive a data but i can't able to question to frematics. Previously with 11bit Identifier, i got a results.
My settings are
so by using this settings…
Thank you Ian,
You did indeed answer my question - my apologies to the Forum for my tardiness in verifying the answer and my thanks to you for doing it for me.
This "reply" is more of a footnote to my question and your answer. Texas Instruments…
Part Number: BQ34110 Did a qualified discharge and logged it, see attached.
During the discharge, batt stat remained at 0x4125. The second to last row this changed to 0x0081, and the last row was 0x0001. In this last row, the column FullChgCap changed…
log_with_bqstudio_ev2400.csv
Hi,
I am already shared the log of learning cycle. again its attached. please find it.
Battery Details:
Description: 18.5V 7.2Ah Li-ion Battery Pack(Inbuilt BMS) Nominal Voltage: 18.5V Rated Capacity: 7.2Ah Length…
Other Parts Discussed in Thread: LM2576 Hi all,
I have used LM2576-adj as voltage regulator, Input voltage-24V & O/P voltage- 12V, input & output capacitance are 220uF/50V & 1000uF/25V. The Load @ output is about 1.8A. The inductor @o/p is 220uH with…
Part Number: BQ40Z50-R1 Hi Sir,
I have used the design of BQ40Z50-R1, and when I discharge it at 0.1A to 2.5V, the battery generates a 200mV voltage imbalance.
Is this reasonable? I haven't experienced this phenomenon with the design using BQ20Z655…
The problem seems to happen for TX only, See 2046.C6000 peripheral guide.pdf
section 23.2.4.1.2 when TX serialiser comes out of reset during initialisation, XSTAT[XDATA] is set to 1. not writing to XBUFn causes underrun.
