Hi Anil,
Please take a look at the attached TRM (spruhm8g.pdf). You will find the answer in section 2.2.1 Device Identification. Let us know if you need further assistance.
Cheers!
Krishna
dual_core_delfino_spruhm8g.pdf
I was having the same problem This is what I assembled
It only got up to 100mv under no load but it was stable. When I added a 0.1ohm load it didn't regulate at all.
here is the Design tool exel file 12-01-2015assembly.xlsx
Part Number: LAUNCHXL-F28377S Acqusition Time Problem
Hello,
My problem is as follows:
I am trying to measure ADC time. For this, I am using the least required "ACQPS". For example;
My single adc reads in 80nanosec. For this, least required…
Hello,
The instaspin_bldc demo on the LS31 MCU was ported over from a demo running on a F28035 MCU from the C2000 microcontroller series. There is a good application note that explains the theory behind the various macros used in this demo. You can…
Aditya,
Please try this link and let me know if it works . Just in case there are still issues I'm going to attach the TRM to the thread as well so you can keep working.
Best,
Matthew
spruhm8i.pdf
Hello
Your application is the same as shown in figure 8.1 of the data sheet. The BOM is shown in figure 8.2.
Any of the transformers listed in those table will work. They have all been tested.
Also, the EVM for the LM25184 is configured for your…
5126.spnu515b.pdf
Dear QJ Wang
I wanna watch the TX/RX state,but still have not found the ACK bit in this datasheet”spnu515b”.Could you tell me where to find ACK register bit in the attachment named "spnu515b"? It is better to know which page in this…
Hi Brijesh,
Thank you for your advice, I could re-build PDK completely.
However, during building SBL, some error are still popped.
ディレクトリ: C:\ti\ti-processor-sdk-rtos-j7200-evm-08_00_00_12\pdk_j7200_08_00_00_37\packages\ti\boot\sbl\example\k3MulticoreApp…
