Search tips
Showing 196 results View by: Thread Post Sort by
    Answered

  • INA180: Simulation problems when not Global-ground-referenced

    Resolved
    Part Number: INA180 Other Parts Discussed in Thread: INA185 Tool/software: I'm having problems simulating INA180A3 when not directly GND referenced. It seems like the Spice model references Global simulation ground, rather than local VCC-GND pins. We…
    • Resolved

  • INA180: Tin Soldering and Clawing Issue for TI part

    TI Thinks Resolved
    Part Number: INA180 Tool/software: Dear Sir and Lady, Could you please send me Tin Soldering and Clawing Standard or guideline for TI part, especially for INA180A2QDBVRQ1. Thank you. Niko Liu

  • INA180: INA180A3IDBVR

    TI Thinks Resolved
    Part Number: INA180 Tool/software: Hi There, We are using INA180A3IDBVR for battery charge and discharge current measurements, the application is battery powered and we need to have low current consumption state. The battery always connected to…

  • INA180: Settling time

    TI Thinks Resolved
    Part Number: INA180 Tool/software: Hi Team, Can you tell me what is the settling time for this device? It is not available on the datasheet Thanks! Marvin
    • Answered

  • INA180: Using for bidirectional current sensing

    Resolved
    Part Number: INA180 Other Parts Discussed in Thread: INA181 , Tool/software: Hi, I know INA180 is for unidirectional current sensing. But this is cheaper than INA181. What are the consequences of using INA180 for bidirectional current sensing? I think…
    • Resolved

  • INA180-Q1: EOS Broken

    TI Thinks Resolved
    Part Number: INA180-Q1 Other Parts Discussed in Thread: INA240 Tool/software: Hi Teams, Customers have used the INA180-Q1, but IN+ PIN is broken. Check to see if the negative pressure of the input is the cause. This is the wave. Yellow is SP_L…
    • Answered

  • INA180: INA180 vs OPA365 current sensing results

    Resolved
    Part Number: INA180 Other Parts Discussed in Thread: OPA2365 , OPA365 , INA296B , INA240 Hi all I was doing some simulation about low side current sensing circuit using high speed opamp and current sense amplifiers. Since INA180 has high market rank…
    • Resolved

  • INA180: PSpice simulation

    TI Thinks Resolved
    Part Number: INA180 Other Parts Discussed in Thread: INA283 Tool/software: Hello, I need to simulate INA180A1,2,3 and 4 in PSpice, but this simulation model currently missing in updated library. For it I downloaded it directly from TI webpage and imported…
    • Answered

  • INA180: Is there a possibility that the device will be damaged?

    Resolved
    Part Number: INA180 Tool/software: Hi support team all. If I connect it as shown below, will the device be damaged? The simulation result in TINA showed that a current of 32 mA was flowing through the OUT terminal, which exceeds the absolute maximum…
    • Resolved
    • Answered

  • INA180-Q1: Can the IN+ and IN- of the INA180-Q1 current sensing operational amplifier meet the 5B pulse requirements?

    Resolved
    Part Number: INA180-Q1 Other Parts Discussed in Thread: INA296B-Q1 , INA186-Q1 Tool/software: Can the IN+ and IN- of the INA180-Q1 current sensing operational amplifier meet the 5B pulse requirements? (Note: The front-end circuit will have a TVS tube…
    • Resolved

Didn't find what you are looking for? Post a new question.