Part Number: JFE150 Tool/software: I am trying to create a schematic in PSPICE using the JFE150 device. When searching the parts for this device it returns a part named JFE150_ALL. I can see from the model file and from the png file in the jfe150_test_circuit…
Part Number: JFE150 Other Parts Discussed in Thread: OPA202 , TINA-TI , TPS7A94 , , JFE2140 Tool/software: Hello everyone, I am wokring with the JFE150 and I have a couple of questions about the Application Note from Chris Featherstone.
I tried to reformulate…
Part Number: JFE150 I see that the TINA model for the JFE150 now incorporates the nominal parameters as well as the 'strong' and 'weak' editions. How do I tell TINA to use these variations?
Part Number: JFE150 Tool/software: Hi team,
Figure 6-11 Input-Referred Noise Spectral Density vs Drain-to-Source Current In Figure 6-11, why does the input-referred noise get worse when the drain-to-source current is 7mA or higher? I was under the impression…
Part Number: JFE150 Other Parts Discussed in Thread: OPA202 , Tool/software: I'm studying slpa018 application note, I have some questions about article,
Question 1:H
gm vs frequency curve above seems like a simulation result of TINA, isn't ture…
Part Number: JFE150 Other Parts Discussed in Thread: LMH6624 , OPA202 , TINA-TI , OPA354 Hello everyone,
I am using the JFE150 transistor to develop a low noise transconductance preamplifier. The input of this circuit is an antenna made out of a parallel…
Part Number: JFE150 Other Parts Discussed in Thread: JFE2140 The JFE150 is the only JFET advertised for use as a preamp on the website. In our application the JFE150 preforms just shy of the desired gain for a voltage to current pre-amplifier, the input…
Part Number: JFE150 Hello,
My customer is interested in JFE150 SOT-23 package option, but it is in preview state now. Would you please tell me the RTM schedule of SOT-23 package option?
Best Regards,
Yoshikazu Kawasaki
Part Number: JFE150 Hi.
I've done a charge amplifier with the JFE150 and I've noted as the noise increases
as the input protection diodes are connected to + and - 6V used as power supplies.
Such a power supply voltages are on board and comes from…
Part Number: JFE150 Other Parts Discussed in Thread: TINA-TI , , OPA202 Hi !
I'm using JFE150 Ultra-Low Noise Piezoelectric Amplifier TINA-TI Reference Circuit(SLPM352.ZIP ).
The frequency response of this circuit is about 24kHz@-3dB.
What determines…
