Part Number: LMH6321
Hi Team, seeking your assistance.
Tried connecting the device using the dual- and single-supply configurations on the datasheet (pgs. 16 and 22), but I ran into overcurrent issues when testing these configurations using…
Part Number: LMH6321 Other Parts Discussed in Thread: THS3491 Dear TI sirs,
I need to drive high voltage:10V and low voltage:-5V to the digital pins of deivce.Because the digital instrument of tester I am using only can support the maximum vih(driving…
Part Number: LMH6321 Other Parts Discussed in Thread: INA818 , Hi TI Technical Support Team,
I have designed discrete constant current charge discharge circuit. I am adjusting current between 1mA and 10mA using DAC (output voltage corresponding…
Part Number: LMH6321 Dear all
I would like to ask range of VEF in LMH6321.
When I posted and exchanged about the leakage current of the EF pin of LMH6321 last time at E2E,
I heard that the leak current that flows to the EF pin is about sub-nA…
Part Number: LMH6321 hi,
I am using LMH6321 as a buffer driver for video Line.Output of the DAC is converted to voltage and given to this IC.
Can PIN no 2 i.e, CL be left open?
If not what should be the VCL value? Its given in datasheet that via…
Part Number: LMH6321 Other Parts Discussed in Thread: BUF634A
Hi,
We're designing a unity gain buffer amplifier for a 38 kHz, 0 - 3V or 0 - 5V PWM signal. The specs aren't particularly fussy; the rise and fall times with a slew rate of 10 V/us would…
Part Number: LMH6321 I would like to ask you just in case about the operation of the EF pin.
When Thermal Protection is applied to this pin, the VEF changes as shown in the specifications below. Is there any possibility that the VEF will decrease except…
Other Parts Discussed in Thread: LMH6321 Has anyone played with the LMH6321 as a HF-range coax cable driver? I'm wondering about its IP2, IP3, NF, etc -- wondering if it'd make a decent "output stage" for low-input-Z loop amps and high-input-Z whip amps…
Hi Per,
I don't think it is okay to leave the GND pin open because it is the reference for the internal op-amp that sets the output current limit of the amplifier. Would it be possible for you to connect the GND pin using a resistive divider with R1…
Part Number: LMH6321 Hi,
When we connect LMH6321 tab pin to negative rail supply(-15v).it was taking 140mA,and temperature was rising up to 40*C, when tab pin is left unconnected it was taking 30mA only .
Can you please clarify the above issue . …
