Hello Brian,
The circuit shown above does not have any additional passives for termination and as such is not compliant to HIPERFACE suggestion from Stegman, which we considered in TIDA-00202. HIPEFACE recommend 130-ohm termination, 1k PDs, and 10k…
Part Number: LM7171 Other Parts Discussed in Thread: LM7705 , TLV3541 , OPA365 I suppose this is a more broad question about operating dual supply OPAMPS with a single supply. I have a signal from a current transformer of 1MHz frequency and 3V peak value…
Sorry, I mixed datarate and RX BW, you can use CC1120 with a RX BW up to 200 kHz meaning that CC1120 should be possible to use.
The LVDS interface on CC1120 was included as a debug interface. Hence the usecase was to interface it with a FPGA board with…
Hello Bidault,
You will need an op amp. At high sampling rates, the input source usually cannot support the switch cap circuit within the SAR ADC.
Attached is a TINA file using the OPA365 with a 2V input and ADC sampling at 2MSPS using a simplified…
Part Number: THP210 Other Parts Discussed in Thread: , OPA325 , THS4551 , OPA320 , THS4561 , OPA350 , OPA365 Hi, I am looking to use the THP210 to change a single-ended voltage source of 0-5V to a differential representation for measuring by a 16-bit…
Part Number: ADS8588H Other Parts Discussed in Thread: OPA365 , OPA836 , ADS8528 , ADS8568 , ADS8568EVM-PDK Hi TI experts,
I am looking for a suitable OPAMP buffer for ADS8588H with input voltage range +/- 10V.
For other details & requirements about…
Part Number: LOG114EVM Other Parts Discussed in Thread: LOG114 , OPA365 The LOG114EVM design differs from the recommendations in the LOG114 datasheet. The differences are:
1) The LOG114 datasheet in Figure 2 uses a REF3040 to provide a 4.096V signal…
Hi Folnia,
In your 5Vdc filter, please use the following capacitor filter. Change 100nF to 1uH or 10uH. I would use 10uH, if you are able.
Folnia said: 3)负载可以等效为一个可变电阻加一个很小的并联电容（估计几pF)，通过buffer直流激励来测量流过这个电阻的微电流
Regarding to TIA, please narrow…
