Part Number: SN65HVS882 Other Parts Discussed in Thread: ISO1212 , ISO1211 , I'm trying to integrate the part in my Digital Input module but our digital input fields values are within range of 36-72V, nominal is 60V fo 'ON' value.
what is the optimal…
Part Number: SN65HVS882 Hi Sirs,
Sorry to bother you.
As title,
1. Do we have Digital Output solution can correspond 882?
2. Does 882 need any FW or driver to control?
Thanks!!
Other Parts Discussed in Thread: SN65HVS882 Hello guys,
One of our customers is looking for a device which is like SN65HVS882 without the serdes portion.
Do you have such device?
Your reply would be appreciated.
Best regards,
Kazuya Nakai.
Part Number: SN65HVS882 In Figure 21 of the datasheet, an application circuit demonstrating the system protection for the SN65HVS882 device is shown. for the input terminals, it depends barely on the 1.2kW resistor.
My question is:
- what is the maximum…
Part Number: SN65HVS882 I am trying to support an old design that uses the chip. The RE outputs are left open. Is this OK? I notice in the datasheets that these are tied to an LED to ground.
Hi Anindya,
There is no internal integrity check mechanism in serializer parts.
But you should be able to check the integrity by the traditional method of externally forcing the logic.
Regards
Tejas H
Other Parts Discussed in Thread: SN65HVS882 Hello,
We are working on a AM335x evaluation module with a SN65HVS882. I need a kernel module to handle proprely the 8 input, wide 10-34V digital-input serializer for industrial digital inputs (SN65HVS882…
Hi,
Which version of the ICE board do you have, and what is the version of the Industrial SDK that you use? Can you check the LP pin of the SN65HVS882? It should be held high during the entire time the byte is shifted out of the serializer.
Other Parts Discussed in Thread: SN65HVS882 Hello
i would like to have some informations about this component SN65HVS882, that you can find in this link http://www.ti.com/lit/ds/slas642/slas642.pdf
According to the datasheet, for VIPL (Field input…