Texas Instruments (TI) Amplifiers support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search amplifier IC content or ask technical support questions on everything from precision and general purpose operational amplifiers (op amps) to instrumentation and differential amplifiers. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions

  • [FAQ] INA181: How do I properly design an input filter for my INA18x-Q1 device?

    Part Number: INA181 Other Parts Discussed in Thread: INA180 , INA240 How do I properly design an input filter for my INA18x-Q1 device?

  • [FAQ] How to use the ALERT pin of a digital power monitor

    Part Number: INA236 Other Parts Discussed in Thread: INA3221 , INA209 , , INA228 , INA237 I want to use the ALERT pin of a digital power monitor, what should I pay attention to?

  • [FAQ] INA228: Current not reading as expected

    Part Number: INA228 Other Parts Discussed in Thread: SYSCONFIG I’m reading the current register value, but the result is wrong. Why am I not reading the value that I expect to be reading?

  • [FAQ] INA238: Troubleshooting I2C Communication Failures (NACK) in TI Current Sense Power Monitors

    Part Number: INA238 Other Parts Discussed in Thread: PCA9306 , TCA9517 I’m getting a “no acknowledge” (NACK) when I try to communicate with the power monitor.

  • [FAQ] INA229: Registers are reading incorrectly

    Part Number: INA229 Other Parts Discussed in Thread: INA239 Why is it when I try reading a register, it appears that I'm actually reading a completely different register? For example, I read 0x3F but I get the results from register 0x3E instead.

  • [FAQ] INA186-Q1: INA186 - Abs Max ratings

    Part Number: INA186-Q1 Other Parts Discussed in Thread: INA186 Can the INA186 handle a VCM beyond Abs Max for a short amount of time?

  • [FAQ] INA186-Q1: Can the INA186 be used with a PWM input?

    Part Number: INA186-Q1 Other Parts Discussed in Thread: INA186 , INA240 Can the INA186 be used to measure current of a PWM signal?

  • [FAQ] INA630: advantages of differential feedback

    Part Number: INA630 Other Parts Discussed in Thread: INA821 , Tool/software: Dear team, I would like to ask you if there is any app note or document highlighting the advantages of differential feedback? or you could provide me with the information…

  • [FAQ] INA333: Articles from Precision Hub and The Signal

    Part Number: INA333 Tool/software: Making Your Own Difference Amp—sometimes 1% resistors are good enough “I Need High Input Impedance!” “Typical”—what does it mean in a data sheet specification? 2-Wire 4-20 mA Sensor Transmitters: Background…

  • [FAQ] [H] Frequently Asked Questions - High Speed Amplifiers Selection Guide - Variable Gain Amplifiers

    Frequently Asked Questions: Amplifiers >> High Speed Amplifiers >> HSA Selection Guide >> Variable Gain Amplifier Selection Guide JFET Input Bipolar Input CMOS Input FDAS Power Amps VGAs TIAs…

View FAQ threads