Other Parts Discussed in Thread: USB2ANY, LMX2594
I have a 2594 EVM and the TICS Pro control board that loads the registers and it is working fine. I am considering a custom design with an LMX2582. Here are my questions:
1) Can I use the TICS Pro software with the same connector interface to program a custom design with LMX2582?
2) If answer to first question is yes, can I disconnect the serial connector that would be on my custom design and the registers and operation would stay functional?
3) What is the recommended way to load registers on a custom design that uses the LMX2582?