CDCDB2000: CDCDB2000 minimum frequency

Borge Strand-Bergesen

Part Number: CDCDB2000
Other Parts Discussed in Thread: LMK00338, LMK1D1216

Hi,

I need to distribute low-frequency clock references to multiple loads. The CDCDB2000 looks like a good candidate.

My clocks operate between 500Hz and 2MHz. Are these frequencies too low for the part? Is there a reason for its lower bound of 50MHz?

Best regards,

Børge

over 1 year ago

+1 Asim Khan over 1 year ago

TI__Genius 9250 points

Hi Borge,

CDCDB2000 has AC coupled input stage which has a cutoff at 1 MHz. There could be some glitches on the output when operating below that frequency.
We didn't specified lower frequencies currently because we didn't characterized the buffer in the lab for lower frequencies yet.

I would recommend looking at LMK1D1216 for you use case. It could work for your frequency range with similar output swing. Their will be some common mode difference if you really need the LP-HCSL output type. Then you can look at LMK00338 buffer.

Best,

Asim

0 Borge Strand-Bergesen over 1 year ago in reply to Asim Khan

Intellectual 695 points

Thank you! I will have a close look at the LMK1D1216.

Best,

Børge

0 Asim Khan over 1 year ago in reply to Borge Strand-Bergesen

TI__Genius 9250 points

Hi Borge,

Let us know if you have any question related to that after your review.

Best,

Asim

Because of the Thanksgiving holiday in the U.S., TI E2E™ design support forum responses may be delayed from November 25 through December 2. Thank you for your patience.

Clock & timing

Clock & timing forum

CDCDB2000: CDCDB2000 minimum frequency