This thread has been locked.
If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.
Hello Team,
I believe unused output could be left open as described in the datasheet page 11.
Could you please advise us if we can keep unused outputs which has PCB trace on board ? Background of this question is that our customer uses common PCB design for 4 channel system and 2 channel system. Can we just keep unused output floating with PCB trace, or should we connect 100 Ohm termination ?
We would be appreciated if you could advise us by end of tomorrow, 10/25 Tuesday (PST).
Best Regards,
Kawai
Team,
Could you please advise us how we should treat the output pins ? They need to fix design by tomorrow.
It would be better not to add pcb trace on the unused output pins, however, as they use the same design for two systems they cannot change PCB design. When having such unused channels, what would you recommend ? Would it be better to keep floating or connect 100 Ohm termination resistor ?
Best Regards,
Kawai