LMK01010: Single-ended Sine Wave Input

Dung Huynh

Prodigy 130 points

Part Number: LMK01010
Other Parts Discussed in Thread: LMK03000, LMK01000

Can both CLKin0 and CLKin1 be driven by 700 MHz single-ended sine wave? What is the recommended termination scheme?

Thank you.

over 6 years ago

0 Alan O over 6 years ago

TI__Mastermind 32575 points

Yes, refer to Figure 12 in the datasheet for this.

Alan

0 Dung Huynh over 6 years ago in reply to Alan O

Prodigy 130 points

Hello Alan,
Are CLKin0 and CLKin1 considered the same as OSCin? May you please clarify this since I do not see OSCin/OSCin* in the Pin Functions on page 3 and 4 in the datasheet.
DH

0 Alan O over 6 years ago in reply to Dung Huynh

TI__Mastermind 32575 points

Per datasheet: The LMK01000 family is footprint compatible with the LMK03000/02000 family of devices. All CLKout pins are

pin-to-pin compatible, and CLKin0 and CLKin1 are equivalent to OSCin and Fin, respectively.

Alan

0 Dung Huynh over 6 years ago in reply to Alan O

Prodigy 130 points

Alan,

Does CLKin0 and CLKin1 support single-ended sine wave input up to 700 MHz? Figure 14. Recommended OSCin Power for Operation with a Sine Wave Input only shows maximum frequency of 100 MHz. If it can be driven by 700 MHz single-ended sine wave, what is the recommended power for Single-Ended Operation at 700 MHz?

Thank you, DH

0 Alan O over 6 years ago in reply to Dung Huynh

TI__Mastermind 32575 points

Yes, input power should be -10 to +5 dBm.

Alan

Clock & timing

Clock & timing forum

LMK01010: Single-ended Sine Wave Input