ADS5282EVM: Request for HDL Code for ADS5282 FPGA Integration

BANOTH BALU

Part Number: ADS5282EVM
Other Parts Discussed in Thread: ADS5282

Tool/software:

Dear TI Support Team,

I am currently working with the ADS5282 ADC and would like to integrate it with an FPGA. To help move forward with my development, I kindly request any available VHDL or Verilog code that demonstrates interfacing the ADS5282 with an FPGA.

If there are any relevant design documents, application notes, or reference designs, I would greatly appreciate it if you could share them. A link to download such materials, if available, would be very helpful.

Would the code and documentation you may provide support this integration? Please send me any relevant resources so I can evaluate and proceed with the next steps.

Thank you in advance for your support.

Best regards,
balu

3 months ago

0 Rob Reeder 3 months ago

TI__Mastermind 38970 points

Hi Balu,

Unfortunately, this is not available, all FW was developed by a third party vendor that we no longer use.

Regards,

Rob

0 BANOTH BALU 3 months ago in reply to Rob Reeder

Prodigy 250 points

Dear Sir,
I came across a relevant link on the TI E2E support forum where a user shared firmware for the ADS5282 along with an FMC ADC adapter targeting a Spartan-6 device

https://e2e.ti.com/support/data-converters-group/data-converters/f/data-converters-forum/47555/ads5282-along-with-fmc-adc-adapter-in-spartan-6-device

interfacing with the ADS5282

Regards
Balu

0 BANOTH BALU 3 months ago in reply to Rob Reeder

Prodigy 250 points

Dear Sir,

We are currently interfacing the ADS8282 ADC with the ZCU102 board. The ADC is clocked at 40 MHz, and we are applying a 10 MHz input signal to one of the ADC channels.

However, after performing the FFT in the FPGA, we are observing several spurious peaks in the ILA. These spurs are not expected and appear alongside the main tone, even though we are currently testing with only one channel.

Since we plan to use this ADC in our project, we are concerned about these spurious signals. Could you please guide us on how to resolve this issue?

We would appreciate your suggestions on how to proceed further.