ADS54j66EVM firmware not in High speed Data Converter pro

Brian Sun

Other Parts Discussed in Thread: ADS54J66, ADS54J66EVM, LMK04828

Hi,

I am currently trying to connect the ADS54j66EVM module to the TSW14j56 REV D but when i go to select the firmware to download to the board, ADS54j66 is not listed. is there a location where i can download the firmware for ADS54j66EVM or should i be picking one that is already listed?

I already checked the resistor on the back that needs to be removed and it has already been removed for the TSW board.

Any help would be appreciated thank you.

Brian

over 9 years ago

0 jim s over 9 years ago

TI__Guru* 91947 points

HSDCPro Patch v4.10.10.exe.zipBrian,

Please run the attached HSDC Pro patch to add the firmware files.

Regards,

Jim

0 Brian Sun over 9 years ago in reply to jim s

Prodigy 210 points

The patch is unsuccessful I tried running it and it comes back unsuccessful the path is correct. but... i do have HSDC pro V4.10 and the patch says it will only work for version 4.1. Also in the patch i found that ADS54j66 was not listed in the files to be installed.

Thanks for the swift reply and the first attempt!
Brian

0 jim s over 9 years ago in reply to Brian Sun

TI__Guru* 91947 points

Brian,
Uninstall your current version of HSDC Pro and download v4.1 from the High Speed Data Converter Pro GUI tool folder on the TI website. After installing v4.1, run the patch. The current patch calls out the required files as ADS58J66. These work with all versions of the ADS5xJ6x evm's.
Regards,
Jim

0 Brian Sun over 9 years ago in reply to jim s

Prodigy 210 points

this seems to work. what about the LMK chip there is not a ADS58j66-lmk04828. is this the same case where and of the settings will work for LMK04828?

I apologize for asking so many questions i just want to make sure before ruining a relatively expensive part.

Thanks Jim!
Brian

0 jim s over 9 years ago in reply to Brian Sun

TI__Guru* 91947 points

ADS54J66EVM Quick Startup Guide.docxBrian,

This case works when the LMK is loaded with the correct config file. Please see attached quick start guide.

Regards,

Jim

Data converters

Data converters forum

ADS54j66EVM firmware not in High speed Data Converter pro