ADS7029-Q1: Datasheet typo?

Kuramochi Tadahiko

Guru 28715 points

Part Number: ADS7029-Q1

Hi,

I guess there are typos on the datasheet.

Could you check follow pictures?

Best Regards,

Kuramochi

over 7 years ago

0 Abhijeet Godbole over 7 years ago

TI__Expert 5575 points

Hello TQ san

For offset calibration, you will need 16 SCLK falling edges once CS goes low. This also requires to include setup time from CS falling to SCLK falling edge.

Regarding timing diagram there is error in the description. Your understanding is correct. For 8 bit device SDO will have first two bits zero followed by 8 bit conversion result.

Thanks for pointing this out. We will work on getting this corrected

Thanks & Regards
Abhijeet

0 Kuramochi Tadahiko over 7 years ago in reply to Abhijeet Godbole

Guru 28715 points

Abhijeet-san,

Thank you for your answer.

>For offset calibration, you will need 16 SCLK falling edges once CS goes low.

I understood that this means 15 SCLK.

My customer requires to modify the datasheet.

Best Regards,
Kuramochi

0 Abhijeet Godbole over 7 years ago in reply to Kuramochi Tadahiko

TI__Expert 5575 points

Hello Kuramochi san

We will work on modifying the datasheet. It may take month or two to get this updated on the web.

Thanks & Regards
Abhijeet

Data converters

Data converters forum

ADS7029-Q1: Datasheet typo?