i have the same Problem to start HMC-DAQ GUI software as described in this post.
e2e.ti.com/.../873555
i am using Windows 10 1809 LTSC
.net 3.5 is installed
i installed it with no errors,
uninstalled it and lapview sam problem.
i treid 3 pcs no luc.
This thread has been locked.
If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.
i have the same Problem to start HMC-DAQ GUI software as described in this post.
e2e.ti.com/.../873555
i am using Windows 10 1809 LTSC
.net 3.5 is installed
i installed it with no errors,
uninstalled it and lapview sam problem.
i treid 3 pcs no luc.
Hi,
It does not look like .net 3.5 issue,
because our PC does not have it installed.
but our ADS52J90 GUI (HMC-DAQ GUI) and TSW1400 GUI (HSDC Pro) are working fine.
Here are the solutions for your issue.
Please take a look at below:
also Please use the following steps one by one very carefully.
Thank you!
==============
We were unable to reproduce the error in our setup, We believe the following steps might resolve the issue,
1) Uninstall both HSDC Pro and HMC-DAQ GUI
2) Uninstall both LabVIEW Run-Time Engine 2010 and LabVIEW Run-Time Engine 2014
For uninstalling the LabVIEW Runtime Engines go to Control Panel >> Uninstall a program >> National Instruments Software >> Uninstall/Change, then select the above mentioned Runtime Engines and Click on Remove.
3) Install HMC-DAQ GUI with its LabVIEW Run-Time Engine 2010
4) Install HSDC Pro with its LabVIEW Run-Time Engine 2014
Kindly let us know if above stated steps failed to address the issue.
===============
Best regards,
Chen