TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Data converters

Data converters

Data converters forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Data converters support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search data converter IC content or ask technical support questions on everything from analog to digital converters (ADCs) and digital to analog converters (DACs) to high speed ADCs and special function data converters. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] AFE5816: AFE58xx and ADS52xx: Details about LVDS bit and Frame clock of ADS52xx and AFE58xx devices.

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5816 The LVDS bit clock and the frame clock scales down based on the decimation factor. The LVDS bit clock frequency (LCLK) is dependent on the sample rate and the type of wire interface (1-wire or 2-wire). And the sample rate is factor…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE58JD16: True digital TGC devices (e.g. AFE58JD16) with accurate timing of when channel gains are changed vs SPI-controlled TGC devices.

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE58JD16 Digital control of TGC via SPI intended for fixed attenuation/testing. Analog control TGC is piecewise linear but it is possible to specify the timing of uniform and non-uniform time gain control using programmed settings on our…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] TX517EVM: Provide details about the TX517 EVM power supplies and their functions.

    Praveen Aroul
    Praveen Aroul
    Part Number: TX517EVM The TX517 EVM requires all 11 power supplies and their functions are listed in the datasheet pin description section. https://e2e.ti.com/support/applications/medical/f/30/t/535845
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5801: Should we buy the interposer card to connect to AFE5801EVM to TSW1400 board?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5801 The AFE5801 EVM ships with the adapter card for the TSW1400EVM . It does not need to be ordered separately. https://e2e.ti.com/support/applications/medical/f/30/t/503459 https://e2e.ti.com/support/applications/medical/f/30/t/…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE58JD18: AFE58JDxx: What should we do with unused JESD CML outputs pin, CLK_1X, CLK_16X input pins?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE58JD18 Unused JESD CML pins, CLK_1X, CLK_16X, NC pins can be left floating. http://e2e.ti.com/support/applications/medical/f/30/t/550784 http://e2e.ti.com/support/applications/medical/f/30/t/547048
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] ADS52J90: How to terminate SYNC_SERDES, SYSREF_SERDES signals in ADS52J90?

    Praveen Aroul
    Praveen Aroul
    Part Number: ADS52J90 SYNC and SYSREF pins’ termination were recently updated to the architecture below in order reduce glitches and false triggers. https://e2e.ti.com/support/applications/medical/f/30/t/585265
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5809: How to load the saved settings at startup in AFE5809? Will the profile ram hold the configuration values after power off?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5809 User-defined device settings cannot be used to configure the AFE5809 at startup but specific configuration steps can be saved in a CMD file by using the GUI’s “record command” and “save command” features. http://e2e.ti.com/support…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5809: How to access the coefficient memory for the filter coefficient in AFE5809?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5809 For Coefficient memory accesses, the SPI write is different than a standard SPI write of 24 bits. It will be a single SPI cycle access of 120 bits (8 bits of address followed by 112 bits of data with MSB first) The SEN signal should…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5818EVM: Provide details about the Adapters from HSMC (Altera) and FMC (Xilinx) to interface to TI serial LVDS connectors

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5818EVM The following TI adapters can be used with our serial LVDS AFExx and ADSxxxx devices to interface with Altera and Xilinx FPGA boards. http://www.ti.com/tool/HSMC-ADC-BRIDGE?keyMatch=hsmc-adc-bridge&tisearch=Search-EN-Everything…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5818EVM: What are the recommended guidelines to use the ADS529xEVM, AFE58xxEVM with any FPGA board?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5818EVM Refer to the posts below for guidelines to use AFE58xxEVM and ADS529xEVM with any FPGA board. http://www.ti.com/tool/TIDA-00069 https://e2e.ti.com/support/applications/medical/f/30/t/433667 https://e2e.ti.com/support/applications…
    • over 7 years ago
    • Data converters
    • Data converters forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Answered

    ADS7953: Output when 2xVREF > +VA 0 Locked

    457 views
    1 reply
    Latest over 5 years ago
    by Cynthia
  • Answered

    ADS1292RECG-FE: Does the EVM order include the ECG cable to connect to the DB9 connector? 0 Locked

    289 views
    1 reply
    Latest over 5 years ago
    by Alexander Smith
  • Suggested Answer

    DAC60508: Is there any difference in the application code between DAC60508 and DAC80508 Components? 0 Locked

    988 views
    7 replies
    Latest over 5 years ago
    by Paul_Frost
  • Suggested Answer

    ADS1298R: ADS1298R 0 Locked

    740 views
    34 replies
    Latest over 5 years ago
    by Alexander Smith
  • Answered

    DAC8734: DAC8734 noise is too good 0 Locked

    378 views
    3 replies
    Latest over 5 years ago
    by Paul_Frost
  • Suggested Answer

    DAC7802: DAC7802 logical thresholds 0 Locked

    324 views
    1 reply
    Latest over 5 years ago
    by Paul_Frost
  • Suggested Answer

    ADC 0 Locked

    149 views
    1 reply
    Latest over 5 years ago
    by Rob Reeder
  • Suggested Answer

    ADS7142-Q1: Blank EEPROM detected 0 Locked

    593 views
    2 replies
    Latest over 5 years ago
    by Cynthia
  • Answered

    AFE4300: Delays needed after setting some registers 0 Locked

    296 views
    4 replies
    Latest over 5 years ago
    by Kenan Habib
  • Suggested Answer

    AMC1306M25: Read data DOUT Pin. 0 Locked

    336 views
    1 reply
    Latest over 5 years ago
    by Alexander Smith
  • Answered

    ADS112U04: Byte /bit order 0 Locked

    320 views
    2 replies
    Latest over 5 years ago
    by hiral chaudhari
  • Answered

    CCS / ADS1299:Test signal is incorrect 0 Locked

    327 views
    4 replies
    Latest over 5 years ago
    by Alexander Smith
  • Answered

    ADS1298: ADS1298: Skewed output! 0 Locked

    246 views
    3 replies
    Latest over 5 years ago
    by Alexander Smith
  • Answered

    ADS42LB69: ADS42LB69 power up sequence 0 Locked

    388 views
    1 reply
    Latest over 5 years ago
    by jim s
  • Answered

    ADS42LB69: maximum RESET pulse width t2 0 Locked

    345 views
    1 reply
    Latest over 5 years ago
    by jim s
  • Suggested Answer

    TSW14J56EVM: HSDC Pro Data Folder 0 Locked

    396 views
    1 reply
    Latest over 5 years ago
    by jim s
  • Answered

    TLV1543: ESD rating 0 Locked

    270 views
    2 replies
    Latest over 5 years ago
    by Roland Melad
  • Suggested Answer

    DAC8551EVM: Block Diagram Question 0 Locked

    756 views
    1 reply
    Latest over 5 years ago
    by Akhilesh K
  • Suggested Answer

    DAC8830: Planning to use OPA445 and DAC8830 to generate voltage 0 to 50V 0 Locked

    379 views
    1 reply
    Latest over 5 years ago
    by Akhilesh K
  • Suggested Answer

    DAC80508: IAM NOT ABLE GET ANY device ID and any output voltage on dac 0 Locked

    1700 views
    18 replies
    Latest over 5 years ago
    by Akhilesh K
<>