TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Data converters

Data converters

Data converters forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Data converters support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search data converter IC content or ask technical support questions on everything from analog to digital converters (ADCs) and digital to analog converters (DACs) to high speed ADCs and special function data converters. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] AFE5816: AFE58xx and ADS52xx: Details about LVDS bit and Frame clock of ADS52xx and AFE58xx devices.

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5816 The LVDS bit clock and the frame clock scales down based on the decimation factor. The LVDS bit clock frequency (LCLK) is dependent on the sample rate and the type of wire interface (1-wire or 2-wire). And the sample rate is factor…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE58JD16: True digital TGC devices (e.g. AFE58JD16) with accurate timing of when channel gains are changed vs SPI-controlled TGC devices.

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE58JD16 Digital control of TGC via SPI intended for fixed attenuation/testing. Analog control TGC is piecewise linear but it is possible to specify the timing of uniform and non-uniform time gain control using programmed settings on our…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] TX517EVM: Provide details about the TX517 EVM power supplies and their functions.

    Praveen Aroul
    Praveen Aroul
    Part Number: TX517EVM The TX517 EVM requires all 11 power supplies and their functions are listed in the datasheet pin description section. https://e2e.ti.com/support/applications/medical/f/30/t/535845
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5801: Should we buy the interposer card to connect to AFE5801EVM to TSW1400 board?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5801 The AFE5801 EVM ships with the adapter card for the TSW1400EVM . It does not need to be ordered separately. https://e2e.ti.com/support/applications/medical/f/30/t/503459 https://e2e.ti.com/support/applications/medical/f/30/t/…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE58JD18: AFE58JDxx: What should we do with unused JESD CML outputs pin, CLK_1X, CLK_16X input pins?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE58JD18 Unused JESD CML pins, CLK_1X, CLK_16X, NC pins can be left floating. http://e2e.ti.com/support/applications/medical/f/30/t/550784 http://e2e.ti.com/support/applications/medical/f/30/t/547048
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] ADS52J90: How to terminate SYNC_SERDES, SYSREF_SERDES signals in ADS52J90?

    Praveen Aroul
    Praveen Aroul
    Part Number: ADS52J90 SYNC and SYSREF pins’ termination were recently updated to the architecture below in order reduce glitches and false triggers. https://e2e.ti.com/support/applications/medical/f/30/t/585265
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5809: How to load the saved settings at startup in AFE5809? Will the profile ram hold the configuration values after power off?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5809 User-defined device settings cannot be used to configure the AFE5809 at startup but specific configuration steps can be saved in a CMD file by using the GUI’s “record command” and “save command” features. http://e2e.ti.com/support…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5809: How to access the coefficient memory for the filter coefficient in AFE5809?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5809 For Coefficient memory accesses, the SPI write is different than a standard SPI write of 24 bits. It will be a single SPI cycle access of 120 bits (8 bits of address followed by 112 bits of data with MSB first) The SEN signal should…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5818EVM: Provide details about the Adapters from HSMC (Altera) and FMC (Xilinx) to interface to TI serial LVDS connectors

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5818EVM The following TI adapters can be used with our serial LVDS AFExx and ADSxxxx devices to interface with Altera and Xilinx FPGA boards. http://www.ti.com/tool/HSMC-ADC-BRIDGE?keyMatch=hsmc-adc-bridge&tisearch=Search-EN-Everything…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5818EVM: What are the recommended guidelines to use the ADS529xEVM, AFE58xxEVM with any FPGA board?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5818EVM Refer to the posts below for guidelines to use AFE58xxEVM and ADS529xEVM with any FPGA board. http://www.ti.com/tool/TIDA-00069 https://e2e.ti.com/support/applications/medical/f/30/t/433667 https://e2e.ti.com/support/applications…
    • over 7 years ago
    • Data converters
    • Data converters forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Answered

    ADS1015: Exceeding Max Analog Input Voltage 0 Locked

    931 views
    3 replies
    Latest over 5 years ago
    by Joseph Wu
  • Suggested Answer

    DDC232: DDC232 get noise 0 Locked

    378 views
    1 reply
    Latest over 5 years ago
    by Eduardo Bartolome
  • Answered

    ADS8688EVM-PDK: need win10 version SDCC driver 0 Locked

    446 views
    1 reply
    Latest over 5 years ago
    by Dale Li
  • Answered

    ADS1292R: ADS1292R Using RLD. Could the IN1 be used as the RLD signal source? 0 Locked

    542 views
    4 replies
    Latest over 5 years ago
    by Ryan Andrews
  • Answered

    DAC11001A: What is the update rate with de-glitcher enabled? 0 Locked

    826 views
    11 replies
    Latest over 5 years ago
    by Justin Scott
  • Suggested Answer

    DDC264EVM: DDC264EVM Noise on channels 0 Locked

    647 views
    2 replies
    Latest over 5 years ago
    by Eduardo Bartolome
  • Answered

    DDC232: Maybe DDC232 is damaged 0 Locked

    386 views
    7 replies
    Latest over 5 years ago
    by Eduardo Bartolome
  • Answered

    ADS1299EEGFE-PDK: Pipe for using outside programs 0 Locked

    167 views
    1 reply
    Latest over 5 years ago
    by Alexander Smith
  • Suggested Answer

    ADS1299EEGFE-PDK: Cannot get right signal (just glitches) 0 Locked

    625 views
    5 replies
    Latest over 5 years ago
    by Alexander Smith
  • Suggested Answer

    ADS1299: ADS1299 few drdy pulses 0 Locked

    293 views
    1 reply
    Latest over 5 years ago
    by Alexander Smith
  • Answered

    DAC60502: Schedule of RTM 0 Locked

    351 views
    1 reply
    Latest over 5 years ago
    by Paul_Frost
  • Not Answered

    AFE4300: ADC Resolution 0 Locked

    255 views
    1 reply
    Latest over 5 years ago
    by Praveen Aroul
  • Answered

    ADC08B3000: About adc08b3000 test pattern output functions 0 Locked

    390 views
    4 replies
    Latest over 5 years ago
    by user6238924
  • Answered

    ADC12DJ2700EVM: Setup synchronization for 4ch simultaneous sampling 0 Locked

    468 views
    3 replies
    Latest over 5 years ago
    by Takashi Onawa
  • Not Answered

    DAC8580: Question about DAC8580 Data-Sheet 0 Locked

    375 views
    14 replies
    Latest over 5 years ago
    by user6188735
  • Suggested Answer

    TLA2024: I2C Acknowledge Failed 0 Locked

    702 views
    3 replies
    Latest over 5 years ago
    by Joseph Wu
  • Suggested Answer

    ADS5295: About 14x or 16x serialization mode! 0 Locked

    482 views
    2 replies
    Latest over 5 years ago
    by sungsik kang1
  • Answered

    ADS8900B: Noise Density 0 Locked

    363 views
    4 replies
    Latest over 5 years ago
    by Erik Anderson41
  • Answered

    ADC12DJ5200RFEVM: Interfacing with TSW14J56? 0 Locked

    329 views
    3 replies
    Latest over 5 years ago
    by jim s
  • Suggested Answer

    DAC38J84: IBIS-AMI model issue 0 Locked

    532 views
    2 replies
    Latest over 5 years ago
    by Kang Hsia
<>