TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Data converters

Data converters

Data converters forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Data converters support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search data converter IC content or ask technical support questions on everything from analog to digital converters (ADCs) and digital to analog converters (DACs) to high speed ADCs and special function data converters. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] AFE5816: AFE58xx and ADS52xx: Details about LVDS bit and Frame clock of ADS52xx and AFE58xx devices.

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5816 The LVDS bit clock and the frame clock scales down based on the decimation factor. The LVDS bit clock frequency (LCLK) is dependent on the sample rate and the type of wire interface (1-wire or 2-wire). And the sample rate is factor…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE58JD16: True digital TGC devices (e.g. AFE58JD16) with accurate timing of when channel gains are changed vs SPI-controlled TGC devices.

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE58JD16 Digital control of TGC via SPI intended for fixed attenuation/testing. Analog control TGC is piecewise linear but it is possible to specify the timing of uniform and non-uniform time gain control using programmed settings on our…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] TX517EVM: Provide details about the TX517 EVM power supplies and their functions.

    Praveen Aroul
    Praveen Aroul
    Part Number: TX517EVM The TX517 EVM requires all 11 power supplies and their functions are listed in the datasheet pin description section. https://e2e.ti.com/support/applications/medical/f/30/t/535845
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5801: Should we buy the interposer card to connect to AFE5801EVM to TSW1400 board?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5801 The AFE5801 EVM ships with the adapter card for the TSW1400EVM . It does not need to be ordered separately. https://e2e.ti.com/support/applications/medical/f/30/t/503459 https://e2e.ti.com/support/applications/medical/f/30/t/…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE58JD18: AFE58JDxx: What should we do with unused JESD CML outputs pin, CLK_1X, CLK_16X input pins?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE58JD18 Unused JESD CML pins, CLK_1X, CLK_16X, NC pins can be left floating. http://e2e.ti.com/support/applications/medical/f/30/t/550784 http://e2e.ti.com/support/applications/medical/f/30/t/547048
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] ADS52J90: How to terminate SYNC_SERDES, SYSREF_SERDES signals in ADS52J90?

    Praveen Aroul
    Praveen Aroul
    Part Number: ADS52J90 SYNC and SYSREF pins’ termination were recently updated to the architecture below in order reduce glitches and false triggers. https://e2e.ti.com/support/applications/medical/f/30/t/585265
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5809: How to load the saved settings at startup in AFE5809? Will the profile ram hold the configuration values after power off?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5809 User-defined device settings cannot be used to configure the AFE5809 at startup but specific configuration steps can be saved in a CMD file by using the GUI’s “record command” and “save command” features. http://e2e.ti.com/support…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5809: How to access the coefficient memory for the filter coefficient in AFE5809?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5809 For Coefficient memory accesses, the SPI write is different than a standard SPI write of 24 bits. It will be a single SPI cycle access of 120 bits (8 bits of address followed by 112 bits of data with MSB first) The SEN signal should…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5818EVM: Provide details about the Adapters from HSMC (Altera) and FMC (Xilinx) to interface to TI serial LVDS connectors

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5818EVM The following TI adapters can be used with our serial LVDS AFExx and ADSxxxx devices to interface with Altera and Xilinx FPGA boards. http://www.ti.com/tool/HSMC-ADC-BRIDGE?keyMatch=hsmc-adc-bridge&tisearch=Search-EN-Everything…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5818EVM: What are the recommended guidelines to use the ADS529xEVM, AFE58xxEVM with any FPGA board?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5818EVM Refer to the posts below for guidelines to use AFE58xxEVM and ADS529xEVM with any FPGA board. http://www.ti.com/tool/TIDA-00069 https://e2e.ti.com/support/applications/medical/f/30/t/433667 https://e2e.ti.com/support/applications…
    • over 7 years ago
    • Data converters
    • Data converters forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Not Answered

    ADS7951: analog I/P setting after chan cahnge and acquisition phase 0 Locked

    727 views
    2 replies
    Latest over 7 years ago
    by user4742059
  • Suggested Answer

    DAC9881: DAC Output is not consistent 0 Locked

    1018 views
    5 replies
    Latest over 7 years ago
    by Paul_Frost
  • Suggested Answer

    ADS1298: ADS 1298 Development for Arduino 0 Locked

    680 views
    1 reply
    Latest over 7 years ago
    by Alexander Smith
  • Suggested Answer

    ADS1299EEGFE-PDK: mmb0 Evalboard, driver problem 0 Locked

    708 views
    1 reply
    Latest over 7 years ago
    by Alexander Smith
  • Not Answered

    TSW1400EVM: TSW1400 reparing 0 Locked

    292 views
    1 reply
    Latest over 7 years ago
    by Matthias Feulner
  • Answered

    DAC38RF82: Dual DAC creating IBW of 2GHz 0 Locked

    943 views
    6 replies
    Latest over 7 years ago
    by Hendrik Nel
  • Answered

    ADS131A02: SPI Driver example code 0 Locked

    761 views
    3 replies
    Latest over 7 years ago
    by Alexander Smith
  • Suggested Answer

    DAC8775: Adaptive power management 0 Locked

    320 views
    1 reply
    Latest over 7 years ago
    by Garrett Satterfield
  • Suggested Answer

    TSW1400EVM: when I click the Trigger Frame button in radar studio, there are errors that I can't solve .Could you help me? 0 Locked

    509 views
    2 replies
    Latest over 7 years ago
    by Jitendra Gupta
  • Answered

    ADS5463EVM: Suggestion on 1GHz/500MHz external clock module for 500 MHz system synchronous design. 0 Locked

    560 views
    2 replies
    Latest over 7 years ago
    by vinitk99
  • Answered

    TSW1400EVM: trigger capability 0 Locked

    606 views
    4 replies
    Latest over 7 years ago
    by jim s
  • Suggested Answer

    ADS7946: How to calculate the input RC filter 0 Locked

    1056 views
    1 reply
    Latest over 7 years ago
    by Abhijeet Godbole
  • Suggested Answer

    AFE4300: SPI Read write issue 0 Locked

    923 views
    3 replies
    Latest over 7 years ago
    by Prabin Yadav
  • Answered

    AFE5818: DVDD_1P2 voltage rail rise time 0 Locked

    370 views
    2 replies
    Latest over 7 years ago
    by JUDSON ANTU
  • Suggested Answer

    DAC1282: PWDN/RESET timing 0 Locked

    687 views
    6 replies
    Latest over 7 years ago
    by Andrew Kinmont79
  • Not Answered

    ADC12DJ3200: ADC12DJ3200 interfacing with Xilinx kintex Ultrascale (KCU105)- Data Extraction 0 Locked

    1300 views
    5 replies
    Latest over 7 years ago
    by jim s
  • Answered

    ADS1015: Read config register 0 Locked

    3216 views
    4 replies
    Latest over 7 years ago
    by Hyemin Kwon
  • Suggested Answer

    ADS122U04EVM: Too mach noise ADS122U04 0 Locked

    875 views
    2 replies
    Latest over 7 years ago
    by Ivan Bulaev
  • Suggested Answer

    DDC232: DDC112 / DDC114 / DDC118 / DDC1128 / DDC2256A / DDC232 / DDC264 / DDC316 FAQs 0 Locked

    2524 views
    1 reply
    Latest over 7 years ago
    by Eduardo Bartolome
  • Answered

    ADC3244: Creating dBFS spectral plots from ADC count data that compare well with those of the data sheet 0 Locked

    906 views
    1 reply
    Latest over 7 years ago
    by Roger Backhus
<>