TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Data converters

Data converters

Data converters forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Data converters support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search data converter IC content or ask technical support questions on everything from analog to digital converters (ADCs) and digital to analog converters (DACs) to high speed ADCs and special function data converters. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] AFE5816: AFE58xx and ADS52xx: Details about LVDS bit and Frame clock of ADS52xx and AFE58xx devices.

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5816 The LVDS bit clock and the frame clock scales down based on the decimation factor. The LVDS bit clock frequency (LCLK) is dependent on the sample rate and the type of wire interface (1-wire or 2-wire). And the sample rate is factor…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE58JD16: True digital TGC devices (e.g. AFE58JD16) with accurate timing of when channel gains are changed vs SPI-controlled TGC devices.

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE58JD16 Digital control of TGC via SPI intended for fixed attenuation/testing. Analog control TGC is piecewise linear but it is possible to specify the timing of uniform and non-uniform time gain control using programmed settings on our…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] TX517EVM: Provide details about the TX517 EVM power supplies and their functions.

    Praveen Aroul
    Praveen Aroul
    Part Number: TX517EVM The TX517 EVM requires all 11 power supplies and their functions are listed in the datasheet pin description section. https://e2e.ti.com/support/applications/medical/f/30/t/535845
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5801: Should we buy the interposer card to connect to AFE5801EVM to TSW1400 board?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5801 The AFE5801 EVM ships with the adapter card for the TSW1400EVM . It does not need to be ordered separately. https://e2e.ti.com/support/applications/medical/f/30/t/503459 https://e2e.ti.com/support/applications/medical/f/30/t/…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE58JD18: AFE58JDxx: What should we do with unused JESD CML outputs pin, CLK_1X, CLK_16X input pins?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE58JD18 Unused JESD CML pins, CLK_1X, CLK_16X, NC pins can be left floating. http://e2e.ti.com/support/applications/medical/f/30/t/550784 http://e2e.ti.com/support/applications/medical/f/30/t/547048
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] ADS52J90: How to terminate SYNC_SERDES, SYSREF_SERDES signals in ADS52J90?

    Praveen Aroul
    Praveen Aroul
    Part Number: ADS52J90 SYNC and SYSREF pins’ termination were recently updated to the architecture below in order reduce glitches and false triggers. https://e2e.ti.com/support/applications/medical/f/30/t/585265
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5809: How to load the saved settings at startup in AFE5809? Will the profile ram hold the configuration values after power off?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5809 User-defined device settings cannot be used to configure the AFE5809 at startup but specific configuration steps can be saved in a CMD file by using the GUI’s “record command” and “save command” features. http://e2e.ti.com/support…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5809: How to access the coefficient memory for the filter coefficient in AFE5809?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5809 For Coefficient memory accesses, the SPI write is different than a standard SPI write of 24 bits. It will be a single SPI cycle access of 120 bits (8 bits of address followed by 112 bits of data with MSB first) The SEN signal should…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5818EVM: Provide details about the Adapters from HSMC (Altera) and FMC (Xilinx) to interface to TI serial LVDS connectors

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5818EVM The following TI adapters can be used with our serial LVDS AFExx and ADSxxxx devices to interface with Altera and Xilinx FPGA boards. http://www.ti.com/tool/HSMC-ADC-BRIDGE?keyMatch=hsmc-adc-bridge&tisearch=Search-EN-Everything…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5818EVM: What are the recommended guidelines to use the ADS529xEVM, AFE58xxEVM with any FPGA board?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5818EVM Refer to the posts below for guidelines to use AFE58xxEVM and ADS529xEVM with any FPGA board. http://www.ti.com/tool/TIDA-00069 https://e2e.ti.com/support/applications/medical/f/30/t/433667 https://e2e.ti.com/support/applications…
    • over 7 years ago
    • Data converters
    • Data converters forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Answered

    How can we get a lower sample rate for PPG using AFE4403? 0 Locked

    509 views
    2 replies
    Latest over 9 years ago
    by Scott Brenneman
  • Answered

    ADS8568EVM-PDK with external sampling clock 0 Locked

    678 views
    3 replies
    Latest over 9 years ago
    by Jose Duenas
  • Answered

    ADS8329 INPUTS 0 Locked

    460 views
    1 reply
    Latest over 9 years ago
    by Jose Duenas
  • Answered

    LMP90100 with Raspberry Pi 0 Locked

    1071 views
    3 replies
    Latest over 9 years ago
    by Michael Stout
  • Not Answered

    Could you provide IBIS model of ADC128S022 to me? 0 Locked

    633 views
    1 reply
    Latest over 9 years ago
    by Romain Farkas
  • Not Answered

    SYNC and SYSREF for ADC34J45 0 Locked

    1152 views
    1 reply
    Latest over 9 years ago
    by Ken C
  • Not Answered

    Request for AFE4404 design files 0 Locked

    434 views
    4 replies
    Latest over 9 years ago
    by annamol alex
  • Answered

    For AFE4404EVM initialize sequence 0 Locked

    2327 views
    14 replies
    Latest over 9 years ago
    by Amy Schnoor
  • Discussion

    Firmware for AFE4404EVM Locked

    273 views
    1 reply
    Latest over 9 years ago
    by Amy Schnoor
  • Not Answered

    Additional documentation for ADS52J90EVM (repost) 0 Locked

    476 views
    2 replies
    Latest over 9 years ago
    by Pietro Giannelli
  • Answered

    ADS8509 Tuning for full range without trim circuit 0 Locked

    315 views
    1 reply
    Latest over 9 years ago
    by Shridhar%20More
  • Answered

    ADS5282 EVM Problems 0 Locked

    2429 views
    12 replies
    Latest over 9 years ago
    by Soo Mee Kim
  • Not Answered

    windows 7 driver for ADS5282EVM when using ADC SPI interface on PC 0 Locked

    2835 views
    7 replies
    Latest over 9 years ago
    by Soo Mee Kim
  • Suggested Answer

    lmp90100 getting hang 0 Locked

    434 views
    2 replies
    Latest over 9 years ago
    by Timofeev Boris
  • Suggested Answer

    lmp90100 normal streaming mode issues 0 Locked

    384 views
    1 reply
    Latest over 9 years ago
    by Michael Stout
  • Answered

    ADS1248 wrong measurment values. 0 Locked

    464 views
    3 replies
    Latest over 9 years ago
    by Joseph Wu
  • Answered

    ADS1247 GPIO Output Level (Bipoiar Analog Power) 0 Locked

    820 views
    3 replies
    Latest over 9 years ago
    by Joseph Wu
  • Answered

    what is the exact formula to find the RTD_Value from ADS1247 adc. i am using 3 wire RTD 0 Locked

    3092 views
    11 replies
    Latest over 9 years ago
    by Joseph Wu
  • Answered

    DAC1282 pulse mode 0 Locked

    670 views
    3 replies
    Latest over 9 years ago
    by Barry Basile
  • Answered

    Ecg using ads1298 0 Locked

    514 views
    7 replies
    Latest over 9 years ago
    by Brian Pisani
<>