TPS65994AD: TPS65994AD Configuration

Vu Dinh

Part Number: TPS65994AD
Other Parts Discussed in Thread: TPS65993, , TPS65994

Hi all,

I am using a PD controller (TPS65994AD) and try to flash configurations to EEPROM (CAT24C256). I use TPS65993_4 Application Customization Tool to export *full flash image*. So next step, I only need flash this binary file to EEPROM by starting at address 0x00, right?

Beside that, I use a template configuration file for TPS65994AD and it contains a mount of parameters that make me a little bit confuse. Are there any document helping me understand these parameters and configure?

Thanks you!

Vu Dinh
Xelex Corporation

over 4 years ago

+1 Adam Mc Gaffin over 4 years ago

TI__Mastermind 30000 points

Hello Vu,

Yes will program the EEPROM starting at 0x00.

As far as the parameter definitions, you can refer to the TPS65994 Host Interface Technical reference manual that should be available on the same site where you downloaded the GUI. This document outlines all of the bytes/bits within the device.

0 Vu Dinh over 4 years ago in reply to Adam Mc Gaffin

Prodigy 20 points

Hi Adam,

I found the document you mentioned. I will try to set my own configurations on TPS65994AD.

Thanks for your supports.
Vu Dinh
Xelex Corporation

Interface

Interface forum

TPS65994AD: TPS65994AD Configuration