• State
  • Locked Locked
  • Replies 2 replies
  • Subscribers 35 subscribers
  • Views 622 views
  • Users 0 members are here
Support feedback
Options
Options
Related

This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

TLIN1028-Q1: TLIN1028-Q1 vs TJA1028

Kygo Cheng
Expert 6830 points
Part Number: TLIN1028-Q1

Hi Team,

There is a good new that we have a chance to DIN   LIN transceiver ! 

Could you share comparison table between TLIN1028-Q1  vs  TJA1028  ? Or let me know the difference between the two 

THX

  • 0
    TI__Guru 74252 points

    Kygo,

    An engineer has been notified of this thread and will respond by tomorrow. Thank you for your patience.

    Regards,

    Eric Hackett 

  • 0 in reply to Eric Hackett
    TI__Genius 15345 points

    Kygo,

    I'm not sure if I'm allowed to share the link online. Can you email me at c-ayoub@ti.com and I can send you the table?

    • When it comes to operational differences, the TJA1028 uses an push pull output on the RXD pin, and the TLIN1028 uses an open drain output.
    • The driver of the TJA1028 is turned on until the EN pin is high and the TXD pin is pulled high. The TLIN driver is immediately turned on when the EN pin is high.
    • There is also a difference in the pull up resistance of the nRST pin. The TJA device uses 3 - 12K resistors in parrallel. The TLIN device uses a 250K resistor.
      • This shouldn't cause any issue

    Best,

    Chris