• State TI Thinks Resolved
  • Locked Locked
  • Replies 1 reply
  • Answers 1 answer
  • Subscribers 33 subscribers
  • Views 200 views
  • Users 0 members are here
Support feedback
Options
Options
Related

This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

DS90UB953-Q1: Forward Channel Mode Selection

Yi Sun
Prodigy 20 points
Part Number: DS90UB953-Q1

Dear TI:
I have a question want to you help me.
the address ox03 about ser953, the bit0 to bit3 is about Forward Channel Mode Selection, I want to know when should I set CSI-2 Synchronous Mode（0b000）， when should I set CSI-2 Non-synchronous Internal AON Clock(0b011)

best regards
Red Sun

  • 0
    TI__Guru** 107810 points

    Hello Yi,

    This register does exactly the same job as the hardware pin 21 (MODE). Please refer to table 7-8 to know the different Modes.

    Chosing the right mode depends on different factors:

    1) MODE settings on the paired DES.

    2) The required Data rate on the transmission channel, and

    3) If you want to use an external Oscillator connected to the SER, to the Imgae sensor or no Oscillator in the Camera.