SN75LVDS82: About the CLKOUT output when the SHTDN is high.

Kengo.Y

Part Number: SN75LVDS82

Hi team,

Even if SHTDNpin is set to high, CLKOUT is not output.
Is there anything else I need to set?
Could you tell me your advice?

Sincerely.
Kengo.

over 5 years ago

0 Michael.Walker over 5 years ago

TI__Mastermind 19720 points

Hi Kengo,

Are you following the power up and power down sequence described in the section "10.2.1.2.1" of the datasheet? What is your CLKIN frequency?

0 Kengo.Y over 5 years ago in reply to Michael.Walker

Guru 11525 points

Hi Michael,

Thank you for your reply.

Yes.
My customer runs according to the power sequence but does not improve.

They use 36MHz.

Could you give me some advice?

Sincerely.
Kengo.

0 Michael.Walker over 5 years ago in reply to Kengo.Y

TI__Mastermind 19720 points

Hi Kengo,

Can you attach your schematic?

0 Kengo.Y over 5 years ago in reply to Michael.Walker

Guru 11525 points

Hi Michael,
Can I talk offline?
I'll request a frendship in E2E.

Sincerely.
Kengo.

0 Michael.Walker over 5 years ago in reply to Kengo.Y

TI__Mastermind 19720 points

I have accepted your friendship request.

0 Michael.Walker over 5 years ago in reply to Michael.Walker

TI__Mastermind 19720 points

Thank you for sending me your schematic. How are you measuring your CLKIN signal? are you using a differential probe?

Interface

Interface forum

SN75LVDS82: About the CLKOUT output when the SHTDN is high.