TLK100: 1.8V POWER OUT

Hello, 

Thank you for the query. The core voltage is specified as 1.55. You should be able to use few micros of current but would need to be tested with the device on the behavior during powerup or reset. 

Where did you get the 1.8V number ?

Also please check the pin number 

https://www.ti.com/lit/ds/symlink/tlk110.pdf

Regards,

Sreenivasa 

Hello 

Thanks you.

Regards,

Sreenivasa

Hello 

The supply rang is 1.7 to 1.9V. The PFBOUT is expected to be within this range.

Regards,

Sreenivasa

Hello, 

The PFBOUT is an infernal regulator optimized to generate the supply rails for the device operation.

They are not expected to power any external loads. Since you wee looking to power a simple gate, this seemed acceptable.

I do not see the LDO current specification mentioned that i could share or point to.

Regards,

Sreenivasa