DP83867IR: Test mode

Takashi Onawa

Part Number: DP83867IR

Hi Team,

My customer want to set the DP83867 to test mode but they forgot to put any code in control processer to switch the mode for compliance test.

Are there any way to switch the device to test mode except MDIO commend?

Regards,

Takashi Onawa

0 Kallikuppa Sreenivasa over 4 years ago

Hello Takashi Onawa

Thank you for the query.

The test mode involves programming registers through the MDIO interface.

Regards,

Sreenivasa

0 Takashi Onawa over 4 years ago in reply to Kallikuppa Sreenivasa

Hi Sreenivasa-san,

Thanks for your prompt response, But I'm asking if there is device mode control method "except MDIO", like GPIO and JTAG.

Do you mean there is no way to switch the mode except MDIO command?

Regards,

Takashi Onawa

+1 Kallikuppa Sreenivasa over 4 years ago in reply to Takashi Onawa

Hello Takashi Onawa

Thank you for the reply.

Yes that is right, the configurations are done through the MDIO.

Has customer connected the MDIO pins on the DP83867 that can be connected to external MDIO board ?

If there is a schematics, i can check.

Regards,

Sreenivasa

0 Takashi Onawa over 4 years ago in reply to Kallikuppa Sreenivasa

Hi Sreenivasa-san,

Thanks for your prompt response on this.

OK, I understand there is no way except MIDO control and open new thread if I need additional helps.

Regards,

Takashi Onawa

0 Kallikuppa Sreenivasa over 4 years ago in reply to Takashi Onawa

Hello Takashi Onawa

Noted and thank you.

Regards,

Sreenivasa

Interface forum