DS100BR410: Fast(100M) ether redriver

Kazuki Kuramochi

Part Number: DS100BR410

Hello Expert,

Our customer is looking for redriver IC for Fast(100M) ether.
They have use DS100BR410 but this device can support 1G ether and this is over spec their requirement.
Then, I confirmed TI.com but I couldn't found the device for Fast ether.

Is there any redriver IC which is design for Fast ether?

Thank you and best regards.
Kazuki Kuramochi

over 3 years ago

0 Rodrigo Natal over 3 years ago

TI__Mastermind 19235 points

Can you confirm the customer data encoding type for this case? Technically speaking the redriver can support any input signal from DC up to 10G. However as part of retimer validation we only tested for 8B/10B and 64B/66b encodings.

Thanks,

Rodrigo Natal

0 Kazuki Kuramochi over 3 years ago in reply to Rodrigo Natal

TI__Genius 11375 points

Rodrigo-san,

We don't need to support the data rate up to 10G.
They just want to know about whether there is redriver for 100Mbps ethernet in our port folio due to DS100BR410 can support 100Mbps ether but this device's performance is too much for 100Mbps.
Is there such a device?

Thank you and best regards,
Kazuki Kuramochi.

+1 Rodrigo Natal over 3 years ago in reply to Kazuki Kuramochi

TI__Mastermind 19235 points

You may run DS100BR410 at 100Mbps. We do not have redriver part number that is 100M only.

0 Kazuki Kuramochi over 3 years ago in reply to Rodrigo Natal

TI__Genius 11375 points

Hello,

Thank you for your swift reply.
I understand that DS100BR410 is most cost effective device for 100Mbps redriver opportunity due to we don't have specific device for 100Mbps.

Thank you and best regards,
Kazuki Kurmochi

Interface

Interface forum

DS100BR410: Fast(100M) ether redriver