Hello TI Forum!
My intention is to measure the SGMII signal voltage and other electrical characteristics of the SGMII signal from DP83867IS PHY.
Below is the test setup I am planning to execute with the evaluation boards I have:
RGMII evaluation board will be configured using an external MDC/MDIO host to generate the PRBS signals through the MDI interface and the SGMII signal will be looped back externally on the other end of the SGMII evaluation board.
SGMII signal electrical parameters will be measured from the SGMII evaluation board.
Could you please verify the feasibility of this testing? (Any suggestion would be appreciated)
Thank you!
