• State TI Thinks Resolved
  • Locked Locked
  • Replies 1 reply
  • Answers 1 answer
  • Subscribers 32 subscribers
  • Views 146 views
  • Users 0 members are here
Support feedback
Options
Options
Similar topics

This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

TCAN1051HG-Q1: Effective termination resistances range

Yuto Kitamura
Expert 4000 points
Part Number: TCAN1051HG-Q1
Other Parts Discussed in Thread: TCAN1051

Hi team, 

How much is the effective termination resistances range of TCAN1051HG-Q1.

I found that it is 45-70ohm for TCA1043-Q1 on the another E2E thread.

Is it same for TCAN1051?

https://e2e.ti.com/support/interface-group/interface/f/interface-forum/800559/tcan1043-q1-can-bus-stub-node-design-question?tisearch=e2e-sitesearch&keymatch=stub%2520nodes#

We need this value to decide the termination resistor value for stub nodes.

Yuto

  • 0
    TI__Mastermind 49995 points

    Hi Yuto-san,

    We typically specify the driver characteristics of our CAN transceivers over a range of differential loads. We do this so that the behavior of the transceiver can be assumed across a range of different loads that may exist in various systems. For TCAN1051, the datasheet specifies the primary driver behavior across 50Ω < RL <65Ω. Additional specified behavior is also available up to a 45Ω load, though at this load the required Vdiff of 1.5V for CAN is no longer guaranteed. 

    Let me know if you have any more questions.

    Regards,
    Eric Schott