Hi,
We supplied 5V with vbus pin, and we made reset signal to tusb1310.
And checked pwrpresent pin, but pwrpresent pin was low.
Let me know the reason or solution.
Thanks,
Doohan
This thread has been locked.
If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.
Hi,
We supplied 5V with vbus pin, and we made reset signal to tusb1310.
And checked pwrpresent pin, but pwrpresent pin was low.
Let me know the reason or solution.
Thanks,
Doohan
Doohan:
Do you have voltage divider on Vbus pin? Do you follow power on sequence on figure 3.1?
By the way, this device is NRND.
Regards
Brian
Thanks, you response. and i have more questions!
question 1) we use tusb1310a as ulpi mode, but i know pwrpresent is pin of pipe side.
if ISO_START is high(ulpi mode), is it correct that pwrpresent is low?
question 2) we are using tusb1310a by ulpi mode, i initialzed strapping pin like belows. is is correct?
XTAL_DIS -> 1
SSC_DIS -> 0
PIPI_16BIT -> 0
ISO_START -> 1
ULPI_8BIT -> 0
REFCLKSEL1 -> 1
REFCLKSEL0 -> 1
question 3) how can i check whether initialization of tusb1310a is success or not??
Thnaks,
Doohan
Doohan:
Since this device is NRND and limited resource, we can only support questions in datasheet.
Regards
Brian
nrnd? limited resource? what are you saying?
Tusb1310a is product of TI.. I am asking for datasheet of tusb1310a now.
Doohan:
Sorry for confusion, This device has lots of bugs, that's why we put it as NRND ( not recommend for new design). We only support customer which already in production.
Regards
Brian