TUSB320: Pin capacitance to figure out the pullup resistance range for the I2C bus

+-10% should be fine.

Regards

Brian

Brian, 

thanks for your time and support. 

1. I see the attached screenshot is from page 6 which is under the "Control Pins" section. I do not see any pull up for I2C section below it. Does this pertain to the SDA/SCL lines as well?
2. The 10% you are referring to, do you mean, 10% of the values noted in your screenshot?
3. customer is eager to know the pin capacitance. I have seen these to be around 10pF. Do we have the value by any chance?
   They want to calculate it using /cfs-file/__key/communityserver-discussions-components-files/138/3022.I2C-Bus-Pullup-Resistor-Calculation.pdf

Kind regards,
Rez

1: yes, this is for SCL/SDA as well.

2: yes

3: capacitance for which pic?

Regards

bian

Which value should they use for the SDA/SCL lines? 4.7kΩ?