TCAN1042HGV-Q1: Does it support SAE J1939 standard?

Chase Jeong

Mastermind 9215 points

Part Number: TCAN1042HGV-Q1

Hello TI experts,

my customer wants to know that TCAN1042HGVDQ1 support SAE J1939 standard.

(both HW and SW)

Could you check it?

If it does not support, please recommend a part which can support this standard.

Best regards,

Chase

over 3 years ago

0 Eric Hackett over 3 years ago

TI__Guru 74922 points

Chase,

An engineer has been notified of your question and will respond by end of business CST 02/03/2023.

Regards,

Eric Hackett

0 Eric Schott1 over 3 years ago in reply to Eric Hackett

TI__Guru 53535 points

Hi Chase,

The SAE standards seem primarily focused on system level capability and would not be uniquely dependant on the transceiver. CAN transceivers are typically rated to conform to the ISO 11898-2 physical layer CAN standard which may be referenced by higher-level system standard requirements.

Please refer to the thread linked below.
https://e2e.ti.com/support/interface-group/interface/f/interface-forum/1192090/tcan1042hv-q1-sae-j2284-4-iso-11898-2-and-sae-j1939-17

Regards,
Eric Schott

Interface

Interface forum

TCAN1042HGV-Q1: Does it support SAE J1939 standard?