DS90UB954-Q1EVM: EVM detected but DESER showing incorrect address and null registers

Dhruv Lamba

Part Number: DS90UB954-Q1EVM

Hi,

I recently bought a DS90UB954-EVM to do some margin testing on my link. However, when I plugged it in for the first time, I am unable to see the correct I2C address on info tab, and cannot see any proper register values in the register space. Please see screenshot below.

The board is in its untouched default state, with no jumpers modified, and just a USB cable connected (i.e. no remote devices etc.)

Could you please help?

Thanks,

Dhruv

over 1 year ago

0 Anthony Goldhawk over 1 year ago

TI__Intellectual 1450 points

Hi Dhruv,

Attached below is the 954 EVM User Guide. Can you confirm that the jumper configurations match what is shown in figure 4-1? What power supply is being used?

954EVM User Guide.pdf

Best regards,

Anthony

0 Dhruv Lamba over 1 year ago in reply to Anthony Goldhawk

Prodigy 60 points

Hi Anthony,

I confirmed that my EVM is configured identically to the default config in the aforementioned figure. I am using a 12V 3A supply over J1. Your question about the power supply made me suspect the connector for J1, which was a bit janky.

Happy to report things work as intended now :)

Sorry for the ado about nothing :)