DS90UB926Q-Q1: Deserializer port configuration.

Vijay Balaji

Prodigy 130 points

Part Number: DS90UB926Q-Q1

Hi,

Can I configure RGB lines in this IC, like can I change G lines into B lines.

Any configuration available for this, kindly share the procedure to do that.

over 2 years ago

0 Logan Cummins over 2 years ago

TI__Guru 66870 points

Hello,

Since today is a US public holiday, we will resume activity on this thread tomorrow. Thanks for your patience.

Regards,

Logan

0 Casey McCrea over 2 years ago in reply to Logan Cummins

TI__Guru** 103215 points

Vijay,

The 926 does not have any configurations to change color pins. If you want to change which pins contain what data, you would have to change how the data is input to the upstream serializer device. For example, if you were using a DS90UB925-Q1 serializer upstream, you could change the color input connections on that side for RGB, which would then correspondingly change the color pin outs on the 926 side.

Best Regards,

Casey

0 Vijay Balaji over 2 years ago

Prodigy 130 points

Hello Casey,

Thanks for your reply.

Whether any possibilities available to change configurations on serializer side?

0 Casey McCrea over 2 years ago in reply to Vijay Balaji

TI__Guru** 103215 points

Vijay,

In general, the FPD-Link devices do not manipulate video data - they are meant to pass through pixel data unchanged so if you want to manipulate the pixel color positions, you would need to do that by changing the color positions of the data going into the SER.

Best Regards,

Casey

Interface

Interface forum

DS90UB926Q-Q1: Deserializer port configuration.