LVDS redriver, retimer, buffer ...

d_zero

Genius 4685 points

Other Parts Discussed in Thread: DS25BR150, DS38EP100, DS25BR101, DS25CP104A

Dear Team,

do you have a redriver, retimer, buffer or a similar IC for Sony Low voltage LVDS ( subLVDS)?

Vcm=0.9V

Vod = 150mV

Best Regards,

over 1 year ago

0 Malcolm Lyn over 1 year ago

TI__Mastermind 19580 points

Hi,

You can use a regular LVDS driver coupled with a resistor step down network as detailed here:

https://www.ti.com/lit/an/snla353/snla353.pdf

We don't have any sub-LVDS devices/transceivers.

Best,

Malcolm

0 d_zero over 1 year ago in reply to Malcolm Lyn

Genius 4685 points

Hi Malcom,

we have on both sides LVDS and i want to add in-between a LVDS redriver or buffer.

do you have such a device? both the input and output of the buffer needs to be differential.

Best Regards,

0 Malcolm Lyn 12 months ago in reply to d_zero

TI__Mastermind 19580 points

Hi d,

I'm adding HSD on this thread because I think their devices might be better equipped to handle your solution than anything we have under logic.

Best,

Malcolm

0 David (ASIC) Liu 12 months ago in reply to Malcolm Lyn

TI__Guru**** 157686 points

Malcolm

What is the data rate requirement? Please see this link for a list of LVDS buffer or repeater that we have, https://www.ti.com/interface/lvds-m-lvds-pecl/products.html#404=Buffer%3BRepeater&.

Thanks

david

0 d_zero 11 months ago in reply to David (ASIC) Liu

Genius 4685 points

Hi David,

Data rate is 600Mbps . i was looking for small solution size. either 5ch in one package or single channel package.

I found those to are the smallest solution if i'm not wrong.

Can you tell the difference between DS25BR150 and DS38EP100 ?

Best Regards,

+1 Nasser Mohammadi 11 months ago in reply to d_zero

TI__Guru* 93670 points

Hi Malcolm,DS38EP100 is a passive equalizer while DS25BR150 is an active buffer,

Typically we have 4 channels in one package - 5 channels in one package is not what i am aware of.

Please consider DS25CP104A and DS25BR101. These are four and one channel parts. Additionally there is some level of equalization if needed. Please below note link to these two parts data sheet:

https://www.ti.com/lit/ds/symlink/ds25br101.pdf?ts=1701895657262

https://www.ti.com/lit/ds/symlink/ds25cp104a.pdf?ts=1701895264393

Regards, Nasser

Interface

Interface forum

LVDS redriver, retimer, buffer ...