ONET1130EC-EVM: GUI software

Prajwal Doddaballapura

Part Number: ONET1130EC-EVM
Other Parts Discussed in Thread: ONET1130EC, , USB2ANY

Hi,

We recently purchased the ONET1130EC-EVM with USB ANY. However, we are not able to download the ONET1130EC EVM GUI to load the registry.

ONET1130EC-EVM Evaluation board | TI.com

Could you please share the GUI software to us? Also, advice us on how to load the resigned registry in USB2ANY explorer V2.8.

Best,

over 1 year ago

0 Drew Miller1 over 1 year ago

TI__Mastermind 36703 points

Hi,

Please download USB2ANY Explorer:

https://www.ti.com/tool/download/SLVC695

In the GUI, you will need to set the register address and data for each register you want to write to.

Thanks,

Drew

0 Prajwal Doddaballapura over 1 year ago

Prodigy 15 points

Hi Drew,

Thanks for your reply. I have downloaded the GUI and should use I2C and RFFE module, isnt it?

Could you please share the procedure if you have?

Also, can you share the old GUI, as in the pdf, which looks much easier and visualise to use ?

Best,

0 Drew Miller1 over 1 year ago in reply to Prajwal Doddaballapura

TI__Mastermind 36703 points

Hi Prajwal,

Please use the procedure found in the EVM User's Guide.

https://www.ti.com/lit/pdf/snlu245

Let me check in with some colleagues on the old GUI. I'm unsure of the history of this GUI and why it's not readily available.

Thanks,
Drew

0 Drew Miller1 over 1 year ago in reply to Drew Miller1

TI__Mastermind 36703 points

Hi Prajwal,

Unfortunately the other EVM GUI is no longer supported as it was dependent on a USB controller that got obsoleted. Please use USB2ANY explorer to configure the device.

Thanks,

Drew

0 Prajwal Doddaballapura over 1 year ago in reply to Drew Miller1

Prodigy 15 points

Hi Drew,

Thanks for your response.

Would it possible to share your email, I like to ask few questions in terms of registry settings?

Thanks,

Prajwal

0 Drew Miller1 over 1 year ago in reply to Prajwal Doddaballapura

TI__Mastermind 36703 points

Hi Prajwal,

We're strongly encouraged to keep communication on E2E. Let's continue the conversation on the E2E private messages.

Thanks,

Drew

0 Prajwal Doddaballapura over 1 year ago in reply to Drew Miller1

Prodigy 15 points

Hi Drew,

Thanks. I messaged you on the E2E private message.

0 Drew Miller1 over 1 year ago in reply to Prajwal Doddaballapura

TI__Mastermind 36703 points

Hi Prajwal,

Thanks. Sorry about the delay, I'll get back to you shortly. Today was a holiday.

Thanks,

Drew

Interface

Interface forum

ONET1130EC-EVM: GUI software