DS160PR1601: DS160PR160

Powell Peng

Prodigy 50 points

Part Number: DS160PR1601
Other Parts Discussed in Thread: DS320PR1601, DS320PR1601RSCEVM

Tool/software:

Hello, Could you send me the board file of the DS160PR1601 evaluation board ?

3 days ago

0 Nasser Mohammadi 3 days ago

TI__Guru* 91350 points

Hi Peng,

DS160PR1601 and DS320PR1601 use the same evaluation board. Please use DS320PR1601 EVM for your evaluation purpose.

Also, you can send me a friend request with your company email address so we can discuss this in more details.

Regards, Nasser

0 Powell Peng 2 days ago in reply to Nasser Mohammadi

Prodigy 50 points

Hi, Nasser

I will use DS160PR1601 to design a PCIe add-in card, and the pin pads and pin pitch of the chip are relatively small, so could you send me the board file of the EVM for reference ? My Email is powellp@s2cinc.com.

Regards, Powell

0 Nasser Mohammadi 2 days ago in reply to Powell Peng

TI__Guru* 91350 points

Hi Powell,

Shortly you are going to receive email with instructions to download PCIe Gen5 design files. Please check DS320PR1601 design folder for these documents.

Regards, Nasser

0 Powell Peng 1 day ago in reply to Nasser Mohammadi

Prodigy 50 points

Hi, Nasser

I can't find DS320PR1601 design folder in My secure resources, but only some datasheet of PCIE5-REDRIVERS. Can you please resend the design source file of DS320PR1601RSCEVM(.DSN and .Brd file) to me?

Thanks, Powell

0 Nasser Mohammadi 1 day ago in reply to Powell Peng

TI__Guru* 91350 points

Hi Powell,

I apologize for delay. I thought we had already provided this access. Please check again in 20 minutes and let me know.

Regards, Nasser

0 Powell Peng 17 hours ago in reply to Nasser Mohammadi

Prodigy 50 points

Hi, Nasser

I have one more questions about PCB layout. I find the "P" and "N" connections for serveral lanes of EVM were reversed to simplify PCB routing. I wonder if there some registers should be set ?

Thanks, Powell

0 Nasser Mohammadi 4 hours ago in reply to Powell Peng

TI__Guru* 91350 points

Hi Powell,

No need to set a register. PCIe protocol polling state figures out the polarity reversal. We should be ok.

Regards, Nasser

Interface

Interface forum

DS160PR1601: DS160PR160