SN65LVEP11: Similar part with higher amplitude?

David George

Part Number: SN65LVEP11
Other Parts Discussed in Thread: SN65EL11, CLC006, LMH0002

Tool/software:

I'm looking for a part with SN65LVEP11 but with a 1400mVpp amplitude instead of 800mVpp. The only constraint is that I need the rise time to stay the same. Does anything like this exist?

9 months ago

0 David (ASIC) Liu 9 months ago

TI__Guru**** 177676 points

Hi,

Would SN65EL11 be a possible solution, https://www.ti.com/lit/ds/symlink/sn65el11.pdf?

Thanks

David

0 David George 9 months ago in reply to David (ASIC) Liu

Prodigy 10 points

Hi David,

The rise time is good but it looks like in Figure 6 the amplitude goes up to around 700mV. Is there anything that has the amplitude characteristics of the MC10EP89 (see figure 2 in below PDF), but keeps the rise time of the SN65 family?

https://www.onsemi.com/pdf/datasheet/mc10ep89-d.pdf

Thanks,
David

0 David (ASIC) Liu 9 months ago in reply to David George

TI__Guru**** 177676 points

David

We have CLC006 which is the only part that is functionally the same as the MC10EP89.

Please note we have other cable driver which could be applicable to the design. Please refer to LMH0002 as well.

Thanks

David

0 David George 9 months ago in reply to David (ASIC) Liu

Prodigy 10 points

Hi David,

The LMH0002 looks promising. I will look into this option.

Thanks,

David

Interface

Interface forum

SN65LVEP11: Similar part with higher amplitude?