LMH1219: Lock to UN-Lock time

Toshiro Imi

Expert 7410 points

Part Number: LMH1219

Tool/software:

Hello,

Our customer has a question LMH1219 Lock to Un-Lock time.

Could you help him if you have un-Lock time related information.

Best regards,

over 1 year ago

0 Nick Peabody over 1 year ago

TI__Genius 9209 points

Hi Toshiro-Imi-san,

What does the customer mean by un-lock time? Can you provide an example?

For the lock time, it depends on the data rate. A way to check this is to input a signal and use the LOCK_N pin as an indicator.

Best Regards,

Nick

0 Toshiro Imi 11 months ago in reply to Nick Peabody

TI__Expert 7410 points

Hi Nick-san,

Thank you very much for your suggestion.

Our customer actually needs to know the time from SDI turning to none signal to LOCK_N=Low time.

Best regards,

0 Nick Peabody 11 months ago in reply to Toshiro Imi

TI__Genius 9209 points

Hi Toshiro-san,

LOCK_N goes high when the CDR lock condition is not met. I think the unlock time will depend on the signal generator because of the capacitors on SDI signal generators and the AC coupling capacitors on the TL. Designing a test to verify the actual unlock time would need to incorporate the signal generator to get the turn off timestamp. I currently don't have this information, but can look into it if the customer needs the information.

Best Regards,

Nick

0 Nick Peabody 11 months ago in reply to Nick Peabody

TI__Genius 9209 points

Closing due to inactivity.

Interface

Interface forum

LMH1219: Lock to UN-Lock time