DS280BR810: Minimum data hold time

Konoha Shimizu

Part Number: DS280BR810

Tool/software:

Dear team,

I am currently using the DS280BR810 device. In the datasheet, under section 6.7 Timing Requirements -- Serial Management Bus Interface, the table "SMBus SWITCHING CHARACTERISTICS (SMBus MASTER MODE)" specifies a typical data hold time of 0.9μs. However, the minimum value is not listed in the datasheet. Could you please provide me with this minimum value?

Best regards,

Konoha

7 months ago

+1 Drew Miller1 7 months ago

TI__Mastermind 36793 points

Hi Konoha,

Unfortunately, I don't have data on the minimum hold time. However, please note that the I2C specification has a minimum hold time of 0 us for 400 kHz.

I would not expect any issues using this device with 400 kHz EEPROM.

Thanks,

Drew

0 Konoha Shimizu 7 months ago in reply to Drew Miller1

Prodigy 50 points

Hi Drew,

Thank you for answering my questions.

Thanks,
Konoha

Interface

Interface forum

DS280BR810: Minimum data hold time