TLIN1028-Q1: Question about hysteresis

Chase Jeong

Part Number: TLIN1028-Q1

Tool/software:

Dear TI experts,

My customer got a comment from their end customer about TLIN1028-Q1.

"Reset signals shall use hysteresis to prevent instability with slow rise or fall of the power rail."

I caanot find the section about it. Can TLIN1028-Q1 support hysteresis for reset signal? where can I find it on the datasheet?

If not, could you recommend other device which can support hysteresis for reset signal?

Best regards,

Chase

+1 Michael Ikwuyum 6 months ago

Hi Chase,

Please note that the nRST pin is an output based on Vcc which includes the hysteresis, thanks.

Best Regards,

Michael.

0 Chase Jeong 6 months ago in reply to Michael Ikwuyum

Dear Michael,

Thank you for your support.

Where can I find more detailed description which can explain hysteresis on nRST pin especially TLIN1028A-Q1?

Or general description of hysteresis is also fine.

Best regards,

Chase

+1 Michael Ikwuyum 6 months ago in reply to Chase Jeong

Hi Chase,

Please see this general description of hysteresis here, thanks.

Best Regards,

Michael.

Interface forum