LM5012-Q1: yes

SARFARAJ SAIFI

Part Number: LM5012-Q1
Other Parts Discussed in Thread: LM5012

Tool/software:

hi,

i want to add one circuit R and C for Switching diode protection so kindly guide me how to use and which value we have required Diode RC network (Snubber Circuit).

Thanks

sarfaraj

11 months ago

0 ARPITA NATH 11 months ago

TI__Genius 11142 points

Hi Sarfaraj,

A better way to design to design RC snubber is to leave a placeholder for RC snubber. The RC snubber values are to be calculated experimentally. Please follow the steps for snubber design of LM5012 [steps for designing RC snubber across Diode would be same as if calculated across FET]

Power Tips: Calculate an R-C snubber in seven steps

Note that the C_snub*Vin^2*fsw losses will be dissipated in the R_snub, this will increase with input voltage and snubber capacitance. To avoid burning out the snubber resistor, it is therefore necessary to pay attention to the rated power of the resistor.

Regards

Arpita

0 EricLee 11 months ago

TI__Guru 66251 points

Hello Sarfaraj

There are lots of articles explaining how to design R-C snubber. Please refer https://www.ti.com/document-viewer/lit/html/SSZTBC7 and file:///C:/Users/a0413388/Downloads/2845.RC%20Snubber.pdf

-EL

Interface

Interface forum

LM5012-Q1: yes