DS280MB810: DS280MB810-Pin Mode _schematic review

Kowsalyaa Viswanath

Part Number: DS280MB810

Tool/software:

Hello Team

We are using the DS280MB810 linear repeater for straight-thru and demux application. In which we have designed in default pin-mode configuration for straight-Thru and optional configuration through External EEPROM.

Please find the attached schematics and kindly review it and let us know any design changes required for demux application and for SMBUS master mode configuration.

DS280MB810_Schematic_Review_2025.pdf

4 months ago

0 Drew Miller1 4 months ago

TI__Mastermind 35903 points

Hi Kowsalyaa,

We're reviewing this and will get back to you shortly.

Not sure if you're planning to use this in your design, but wanted to let you know that pin mode control of the MUX cannot be enabled via just EEPROM configuration on the DS280MB810.

Thanks,
Drew

0 Kowsalyaa Viswanath 4 months ago in reply to Drew Miller1

Prodigy 10 points

Hi Drew

Kindly ignore the EEPROM section.

Please review the schematics for pin mode configuration.

kindly let us know any hardware changes required or mention the state of MUXSEL0 & MUXSEL 1 to configuring the below mentioned applications.

1. Demux

2. Straight-Thru

Regards

Kowsalyaa.V

0 Drew Miller1 4 months ago in reply to Kowsalyaa Viswanath

TI__Mastermind 35903 points

Hi Kowsalyaa,

Please find our schematic feedback attached.

0841.Schematic Review.pdf

Regarding cross-point configuration, if you wish to use MUXSEL pins, you will need to enable MUX pin control via a register write.

After this, please reference the diagram below to configure the cross point accordingly.

Thanks,

Drew

Interface

Interface forum

DS280MB810: DS280MB810-Pin Mode _schematic review