DP83867IR: PHY_ID not matching for the connection with ti,dp83867 . How the strap configuration determine the PHY_ID

Hi, 

For you to strap to PHY ID 0, you will have to keep both resistors OPEN for RXD0 and RXD2 pins. Current ID is set to 0'b0101 = 0x05. 
The node is correct. 
Best,
J

For RXD0 and RXD2 if the both resistors are open means its PHY ID will be 0x00 is that correct

How does the reset Pins work for the tidp83867 phy. 

cyriac toms said:

For RXD0 and RXD2 if the both resistors are open means its PHY ID will be 0x00 is that correct

This is correct.

cyriac toms said:

How does the reset Pins work for the tidp83867 phy.

RESET: The active low RESET initializes or re-initializes the DP83867. All internal registers re-initialize to the default state upon assertion of RESET. The RESET input must be held low for a minimum of 1µs.

I have another doubt my software is reading the phy ID as 0x0000 whatever the address i give its always taking 0x00000reset pins are working while initializing . Mdio its zero what will be cause for that

I do not understand what you mean. 

The software will try to read whatever PHY ID you give. 

Do you see any MDIO/MDC signal?

NO MDIO signal is not coming but in mdc clock is coming

Please ensure your source is properly sending out MDIO signal.