Tool/software:
Hi,
Performing HyperLynx SI simulation using SN65CML100DGKG4 part.
Connected LVDS driver output with SN65CML100 input and tried to simulate unable to see any output at SN65CML100 LVDS input pin.
When SN65CML100 replaced with other LVDS receiver getting expected simulation results.
I am using IBIS model which was downloaded from the TI website.
For the same SN65CML100 CML output connected with CML receiver and simulation showing expected result.
Does this IBIS model supports only CML output..? Is there any other IBIS model available for SN65CML100..?
Below is the schematics we were doing simulation.
Regards,
Vinayak Arkachari
