TUSB211A-Q1: TUSB211A-Q1 supply power

Hello,

Yes, VCC can be 5V.

This should not affect the value of the EQ resistors, as the EQ pin only required a specific resistor value to pull the pin down to ground, the Req values in the table below should still apply for a 5V supply system, indicated by the footnote:

Thanks,

Ryan

Hi Ryan,

Could you please review my schematics?

Hi Ilan,

Here is my schematic review: TUSB211A-Q1 RIDEVISION Review.pdf

I see two different USB2 data paths here. Is the ECU connecting to the camera, or is the USB2 signal being split up?

Thanks,

Ryan

Hi Ryan,

The camera is connected to the ECU with cable length of 4.5meter. we need the conditioner near the ECU due to long cable

Hi Ilan,

I would recommend placing the redriver closer to the connector on the ECU board, that way the signal is improved as much as possible as it goes through the signal, and so overcompensation is avoided at the ECU.

Thanks,

Ryan

Hi Ryan,

Yes,the  redriver will be placed closer to the connector on the ECU.thanks for your support