TRS3122E: Verify the Schematic Design

Hi Stuti,

Thanks for reaching out. I've noted this request, and I'll get a response back to you tomorrow. 

Best,

Ethan

Hi Stuti,

This schematic looks good. 

• Charge pump caps are valued properly. Make sure on the layout that these are placed as close to the transceiver as possible and on the same layer (i.e. do not use vias). 
• Un-used inputs are properly tied to GND. RIN1 is fine floating since it has an internal pulldown down as you likely know. 
• FORCEON/OFF pins properly tied high for normal operation. 

Best,

Ethan